Husqvarna 327ES Owners Manual - Page 11

Fitting the loop handle ASSEMBLY Assembling the cutting equipment • Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft. • Fit the bolt, securing plate and wing nut as shown in the diagram. WARNING! ! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury. • Tighten the wing nut. Assembling the angle gear WARNING! Under no circumstances may ! the edge cutter blade be used without the blade guard fitted. Assembling the blade • Assemble the angle gear back on the suppporting tube. Turn the blade so that the drive shaft engages in the angle gear. Fit the blade as follows: A B C D E • Tighten the two screws. 1 Fit the drive disc (A) on the outgoing shaft. Make sure that the edge that fits in the hole of the blade is facing outward. 2 Block the blade rotation by inserting the locking pin in the hole behind the blade guard engaging it in the corresponding hole in the drive disc. 3 Fit the blade (B) on the drive disc. 4 Fit the support flange (C). The support flange must be fitted with its outer edge hard up against the blade. 5 Fit the two washers (D) and the locking screw (E). English - 11