Husqvarna 345FR Owners Manual - Page 15
Assembly - 345 fr
View all Husqvarna 345FR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ASSEMBLY Assembling the handlebar and throttle • Tighten the knob. Transport position, handlebar CAUTION! Some models have the throttle handle fitted at the factory. • Remove the screw at the rear of the throttle handle. • Slide the throttle handle onto the right side of the handlebar, (see diagram). • The handlebar can easily be turned to fit along the shaft for easier transportation and storage. • Loosen the knob.Turn the handlebar clockwise so that the throttle handle rests against the engine. • Now twist the handlebar around the shaft. Tighten the knob. • Align the screw hole in the throttle handle with the hole in the handlebar. • Refit the screw in the hole in the rear of the throttle handle. • Screw the screw through the handle and handlebar. Tighten it. • Unscrew the knob from the handlebar mounting. • Position the handlebar as shown. Fit the mounting components and tighten the knob lightly. • Fit the transport guard to the cutting attachment. Assembling the cutting equipment WARNING! ! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury. 545 RX, 545 RXT 545 FX , 545 FXT 345 FR • Put on the harness and hang the machine from the support hook. Now make a final adjustment so that the machine is in a comfortable working position when it hangs from the harness. WARNING! Never use a cutting ! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness. English - 15