Husqvarna 525RX Operation Manual - Page 14
Fitting the blade guard and saw, blade, Fitting other guards and cutting, attachments
View all Husqvarna 525RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ASSEMBLY Fitting the blade guard and saw blade the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread). K J H L I A • Remove the mounting plate (H). Fit the adapter (I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown. CAUTION! Use the recommended blade guard. See the Technical data section. G F D B C • Fit the drive disc (B) on the output shaft. • Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin (C) in the hole to lock the shaft. • Place the blade (D) and support flange (F) on the output shaft. • Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn • When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade. You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut. Fitting other guards and cutting attachments • Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. Hook the guard onto the fitting on the shaft and secure it with the bolt (L). L B C H A • Fit the drive disc (B) on the output shaft. • Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin (C) in the hole to lock the shaft. 14 - English