Husqvarna 543 XP Owners Manual - Page 39
Saw chain filing and file gauges - chainsaws
View all Husqvarna 543 XP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
TECHNICAL DATA Recommended cutting equipment for Canada The following is a list of recommended cutting equipment for chainsaws Husqvarna 543 XP and 543 XPG. The combinations of powerhead, guide bar and saw chain meet all requirements outlined in the CSA Z62.1-11 Chainsaws and Z62.3-11 Chainsaw Kickback standards. The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding maximum nose radius of a solid bar. As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar. We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available at your dealer. The following cutting attachments are approved for the models Husqvarna 543 XP and 543 XPG. Guide bar Saw chain Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count 13 56 15 0.325 0.050 10T 16 64 Husqvarna H30 66 18 72 13 56 15 0.325 0.058 10T 16 64 Husqvarna H25 66 18 72 Note: For the chains above you are free to choose between 0.050" and 0.058" gauge drive link for the corresponding bar, see the table below. 0.050"/1,3 mm 0.058"/1,5 mm H30 H22 - H25 Saw chain filing and file gauges English - 39