Husqvarna 6021P Owners Manual - Page 9

Before Starting Engine, Important, Add Gasoline, Caution, To Empty Grass Catcher, Add Oil - starting problems

Get Husqvarna 6021P PDF manuals and user guides View all Husqvarna 6021P manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

MOWER IS NOW READY FOR DISCHARGING OPERATION TO EMPTY GRASS CATCHER 1. Lift up on grass catcher using the frame handle. 2. Remove grass catcher with clippings from under lawn mower handle. 3. Empty clippings from bag. NOTE: Do not drag the bag when emptying; it will cause unnecessary wear. Grass catcher frame handle IMPORTANT: • Check oil level before each use. Add oil if needed. Fill to full line on dipstick. • Change the oil after every 25 hours of operation or each season. You may need to change the oil more often under dusty, dirty conditions. See "TO CHANGE ENGINE OIL" in the Maintenance section of this manual. ADD GASOLINE • Fill fuel tank to bottom of tank filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness. CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame. CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Empty the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. Gasoline filler cap BEFORE STARTING ENGINE ADD OIL Your lawnmower is shipped without oil in the engine. For type and grade of oil to use, see "ENGINE" in the Maintenance section of this manual. CAUTION: DO NOT overfill engine with oil, or it will smoke heavily from the muffler on startup. 1. Be sure lawnmower is level. Engine oil cap 2. Remove oil dipstick from oil fill spout. 3. You receive a container of oil with the unit. Slowly pour the entire container down the oil fill spout into the engine. NOTE: Initial oil fill requires only 18 oz. due to residual oil in engine from the manufacturers 100% quality testing. When changing oil you may need 20 oz. 4. Insert and tighten dipstick. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
9
IMPORTANT:
• Check oil level before each use.
Add oil
if needed.
Fill to full line on dipstick.
• Change the oil after every 25 hours of
operation or each season.
You may
need to change the oil more often
under dusty, dirty conditions.
See “TO
CHANGE ENGINE OIL” in the Mainte-
nance section of this manual.
ADD GASOLINE
• Fill fuel tank to bottom of tank filler neck.
Do not overfill.
Use fresh, clean, regular
unleaded gasoline with a minimum of
87 octane.
Do not mix oil with gasoline.
Purchase fuel in quantities that can be
used within 30 days to assure fuel fresh-
ness.
CAUTION:
Wipe off any spilled oil or
fuel.
Do not store, spill or use gasoline
near an open flame.
CAUTION
:
Alcohol blended fuels
(called gasohol or using ethanol or metha-
nol) can attract moisture which leads to
separation and formation of acids during
storage.
Acidic gas can damage the fuel
system of an engine while in storage.
To
avoid engine problems, the fuel system
should be emptied before storage of 30
days or longer.
Empty the gas tank, start
the engine and let it run until the fuel lines
and carburetor are empty.
Use fresh fuel
next season.
See Storage Instructions for
additional information.
Never use engine
or carburetor cleaner products in the fuel
tank or permanent damage may occur.
MOWER IS NOW READY FOR
DISCHARGING OPERATION
TO EMPTY GRASS CATCHER
1.
Lift up on grass catcher using the
frame handle.
2.
Remove grass catcher with clippings
from under lawn mower handle.
3.
Empty clippings from bag.
NOTE
:
Do not drag the bag when empty-
ing;
it will cause unnecessary wear.
BEFORE STARTING ENGINE
ADD OIL
Your lawnmower is shipped without oil in
the engine. For type and grade of oil to
use, see “ENGINE” in the Maintenance
section of this manual.
CAUTION:
DO NOT overfill engine with
oil, or it will smoke heavily from the muffler
on startup.
1.
Be sure lawnmower is level.
2.
Remove oil dipstick from oil fill spout.
3.
You receive a container of oil with the
unit.
Slowly pour the entire container
down the oil fill spout into the engine.
NOTE:
Initial oil fill requires only 18 oz.
due to residual oil in engine from the
manufacturers 100% quality testing. When
changing oil you may need 20 oz.
4.
Insert and tighten dipstick.
Grass
catcher
frame
handle
Engine
oil cap
Gasoline
filler cap