Husqvarna AR19B Owners Manual - Page 35
Replacing the rear wheels, Grease the wheel bearings.
View all Husqvarna AR19B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
MAINTENANCE Replacing the rear wheels Applies to model AR19. 1. Make sure the machine is parked on level ground and that the engine is off. 2. Lower the rear wheel control so that the lawn aerator is resting on the tines. 3. Turn the depth adjustment knob for rear wheel depth/stability clockwise so that the rear wheels are set at minimum depth (= increased stability). 4. Remove the axle nut and washer. Pull out the axle bolt and remove the wheel from the wheel carriage. 5. Install the new wheel with the grease nipple turned outwards and the seals carefully in place on the wheel bushing. Insert the axle bolt through the wheel and the wheel carriage. Fit the washer and nut and tighten firmly. 6. Grease the wheel bearings. Applies to model AR25. 1. Make sure the machine is parked on level ground and that the engine is off. 2. Lower the rear wheel control so that the lawn aerator is resting on the tines. 3. Turn the depth adjustment knob for rear wheel depth/stability clockwise so that the rear wheels are set at minimum depth and increased stability. 4. Remove the hairpin cotter pin (1). 5. Remove the wheel and axle assembly from the machine (2). 6. Refit the hairpin cotter in the axle to prevent loss. 8011-176 8011-096 English - 33