Husqvarna AUTOMOWER 310 Owner Manual - Page 16
Installation, Introduction - Installation, Before the installation of the wires
View all Husqvarna AUTOMOWER 310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
3 Installation 3.1 Introduction - Installation WARNING: Read and understand the safety chapter before you install the product. CAUTION: Use original spare parts and installation material. Note: Refer to www.husqvarna.com for more information about installation. 3.2 Before the installation of the wires You can select to attach the wires with stakes or bury them. You can use the 2 procedures for the same work area. • Bury the boundary wire or the guide wire if you are going to use a dethatcher on the work area. If not, attach the boundary wire or guide wire with stakes. • Cut the grass before you install the product. Make sure that the grass is maximum 10 cm / 4 in. Note: The first weeks after installation the perceived sound level when cutting the grass may be higher than expected. When the product has cut the grass for some time, the perceived sound level is much lower. 3.3 Before the installation of the product • Make a blueprint of the work area and include all obstacles. • Make a mark on the blueprint where to put the charging station, the boundary wire and the guide wire. • Make an eyelet on the blueprint where the guide wire connects to the boundary wire. Refer to To install the guide wire on page 22. • Fill in holes in the lawn. 3.3.1 To examine where to put the charging station • Keep a minimum 3 m / 10 ft. of free space in front of the charging station. • Keep a minimum of 1.5 m / 5 ft. of free space to the right and to the left of the charging station. • Put the charging station near an outdoor power outlet. • Put the charging station on a level surface. max. 5 cm / 2" max. 5 cm / 2" • Put the charging station in the lowest possible section of the work area. • Put the charging station in an area without an irrigation system. • Put the charging station in an area with protection from the sun. • If the charging station is installed on an island, make sure to connect the guide wire to the island. Refer to To make an island on page 18. Note: Holes with water in the lawn can cause damage to the product. 16 - Installation 1220 - 001 - 08.07.2019