Husqvarna AUTOMOWER 430X with installation service Owner Manual - Page 29

20% Use the right and left arrow keys to alternate between the different options. 3.17.3.2 Area 1-5 > How far? Enter the distance in metres along the current wire from the charging station to the remote area where the robotic lawnmower begins mowing. Use the right and left arrow keys to alternate between the different options. Tip! Use the Test function (Area 1-5 > More > Test ) to determine how far it is to the remote area. The distance, stated in metres, will be shown in the lawnmower display when STOP has been pressed. See How to measure the distance to a remote area on page 29. The measured distance shown in the display can be saved directly to the selected remote area. Any current value will be overidden by the new measured distance. ? m / ft. 3.17.3.3 Area 1-5 > How often? How often the robotic lawnmower must be steered to the remote area is selected as a proportion of the total number of times it leaves the charging station. At all other times, the robotic lawnmower starts to mow at the charging station. Select the percentage that corresponds to the size of the remote area relative to the total working area. If the remote area is for instance half of the total working area, 50% must be selected. A lower figure must be specified if the remote area is smaller. If more areas are used, take into account that the total figure cannot exceed 100%. Compare with the examples in Yard layout examples on page 40. Use the number keys to specify share as a percentage. 30% 3.17.3.4 Area 1-5 > Disable Each area can be disabled and enabled without having to reenter the settings. Select Disable and press OK. 3.17.3.5 Test: Area 1-5 To test the selected settings: 1. Place the robotic lawnmower in the charging station. 2. Use the down and the right/left arrow keys to select the area to be tested from the Lawn coverage overview screen. Press OK. 3. Select More and press OK. 4. Select Test and press OK. 5. Press START and close the hatch. 6. The robotic lawnmower will now leave the charging station and begin following the guide wire toward the remote area. Check that the robotic lawnmower can follow the guide wire all along the required distance. 7. The test is approved when the robotic lawnmower can follow the guide wire to the required starting point without any problem. 3.17.3.6 How to measure the distance to a remote area 1. Park the robotic lawnmower in the charging station. 2. In the Area 1-5 > How far? menu function, enter a distance which beyond any doubt exceeds the real figure. The maximum distance that can be entered is 500 metres. 3. Select Area 1-5 > More > Test and press OK. 4. Press START and close the hatch. 5. Press STOP at the required position. The distance is now shown in the display. This figure can now be saved in Area 1-5 > How far?. 3.17.3.7 Area 1-5 > More > Reset An individual area setting can be reset to the factory setting using this function. To reset an area setting, select Area 1-5 > More > Reset using the left right arrow keys followed by OK. 3.17.4 Find charging station The robotic lawnmower can be set to search for the charging station in one or more of the following three ways: Guide, Boundary loop and Charging station. The factory settings are set so that these 3 search options 236 - 001 - 02.10.2017 Installation - 29