Husqvarna AUTOMOWER 450X with installation service Owner Manual - Page 36

Place the mower centrally in your yard. Select Accessories > Automower Connect (robotic lawnmower PIN required) > GeoFence. Activate the function by selecting Activate GeoFence and pressing OK. Select New center point to set the origin for GeoFence. GeoFence sensitivity can be changed to suit your yard. Sensitivity can be set to Low, Medium or High. The higher the sensitivity, the easier the alarm is activated. If the alarm is activated too easily, you should select a lower setting for the GeoFence sensitivity. When putting the robotic lawnmower into storage for a long period, such as during the winter, we recommend turning off the main switch. With the GeoFence function activated, you will need the PIN code in order to turn off the robotic lawnmower. Once the main switch has been turned off, the Connect function will stay active for another 12 hours. After that it will not be possible to communicate with the robotic lawnmower and the GeoFence function will not be active. 3.19.2.7 Communication Communication Use SMS SMS phone numbers Use SMS The SMS function must be activated from the mower menu before it can be used. Select Accessories > Automower Connect (robotic lawnmower PIN required) > Communication > Use SMS. SMS phone numbers The telephone numbers to the mobiles allowed to communicate via SMS must be entered into the list of SMS numbers. The numbers must be entered with their country codes, e.g. (+)46701234567. Use the Test-SMS function to verify the specified telephone number. A text will then be sent to all the telephone numbers on the list. The list can have up to three numbers. With the SMS function activated, an SMS will be sent to all the telephone number in the list if the mower is found outside the GeoFence. Certain information can also be retrieved from the robotic lawnmower by sending it an SMS. An SMS with the command "GET GPS INFO" to the mower will give information concerning its position, the origin of GeoFence and its radius together with the GPS signal strength. Note that the telephone of the sender must be specified in the robotic lawnmower. A maximum of 10 SMS per month can be sent from the mower. 3.19.2.8 Network APN settings The robotic lawnmower must specify APN settings to be able to use and send data via the mobile net. Settings for Husqvarna SIM is default. 3.19.2.9 Reset If you choose the function Reset you will then need to confirm that you want to Proceed with reset of Automower Connect settings. 3.19.3 Headlights The headlights are applicable for Automower 430X and Automower 450X. Settings concerning the headlights are made using this function. The headlights are included for Automower 450X and available as accessory for Automower 430X. 3.19.3.1 Schedule Select when to turn on the headlights in the Schedule sub-menu.Choose between Always ON, Evening only, Evening & night or Always OFF. The headlights are turned on/off for the various schedule alternatives on the following occasions: Evenings only Evenings and nights On At sunset At sunset Off Midnight At sunrise 3.19.3.2 Flashes when fault If Flashes when fault is activated the headlights will flash if the robotic lawnmower has come to a standstill because of a fault. 3.19.4 Ultrasonic Ultrasonic is applicable for Automower 450X. It ensures that the mower reduces speed before it hits an obstacle. This function can be turned off, which means the mower will always operate at a lower speed. 3.19.5 Mower house This function handles the settings for the mower house. Mower house Avoid collision with mower 3.19.5.1 Avoid collisions with mower house If this option is selected, the wear on the mower and the house is reduced, but it can result in more uncut grass around the charging station. Network SIM PIN APN settings SIM PIN This menu is only applicable if you use a non-Husqvarna SIM. 36 - Installation 236 - 001 - 02.10.2017