Husqvarna DT22 Owners Manual - Page 25

Two Minute Rule, Cleaning and Washing, no longer than 2, minutes, Do not exceed 70 bar/1000 PSI water

Page 25 highlights

MAINTENANCE Two Minute Rule The machine may be tipped forward to facilitate access for cleaning or service, but no longer than 2 minutes. If the machine is held in this position for too long, the engine can be damaged by gasoline draining into the crankcase. Should this happen, perform an extra oil change on the engine. Remove the spark plug and turn the engine over a few revolutions with the starter handle before starting the engine again. Cleaning and Washing Regular cleaning and washing will increase the machine's lifespan. Make it a habit to clean the machine directly after use, before the dirt sticks. Check before rinsing that the fuel tank lid is properly in place to avoid getting water in the tank. Use caution when using high-pressure spray because warning decals, instruction signs and the engine can be damaged. Do not exceed 70 bar/1000 PSI water pressure when cleaning. Lubricate the machine after cleaning. This is particularly important if the machine is to be stored. 8060-017 8011-121-1 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

MAINTENANCE
25
Two Minute Rule
The machine may be tipped fOrward tO facilitate
access fOr cleaning Or service, but
no longer than 2
minutes
.
If the machine is held in this pOsitiOn fOr tOO lOng, the
engine can be damaged by gasOline draining intO the
crankcase. ShOuld this happen, perfOrm an extra Oil
change On the engine. RemOve the spark plug and
turn the engine Over a few revOlutiOns with the starter
handle befOre starting the engine again.
Cleaning and Washing
Regular cleaning and washing will increase the
machine’s lifespan. Make it a habit tO clean the
machine directly after use, befOre the dirt sticks.
Check befOre rinsing that the fuel tank lid is prOperly
in place tO avOid getting water in the tank.
Use cautiOn when using high-pressure spray because
warning decals, instructiOn signs and the engine can
be damaged.
Do not exceed 70 bar/1000 PSI water
pressure when cleaning
.
Lubricate the machine after cleaning. This is
particularly impOrtant if the machine is tO be stOred.
8060-017
8011-121-1