Husqvarna GT48XLSi Owners Manual - Page 27

SERVICE AND ADJUSTMENTS SMARTSWITCH IGNITION SYSTEM LIGHTS (See Fig. 49) The SmartSwitch System is equipped with courtesy lights that are used to indicate system functions or faults. FUNCTIONS • The SmartSwitch Ignition (SSI) Button (F) will blink blue while waiting for the correct passcode to be entered. The SSI button will blink green when tractor is ready to start and remain solid green while running. • The park brake symbol (CC) will be lit if the parking brake has not been engaged during a start attempt. • The blade switch symbol (EE) will blink if the attachment clutch control is not in the "DISENGAGED" position during a start attempt. • The Reverse Operation System (ROS) button (G) will be lit when Reverse Operation System is in use. • The Headlight button (H) will remain lit while headlights are in use. • During normal operation, the Battery Indicator Button (I) will not be lit. FAULTS • The SSI Button (F) will blink red for two seconds if the wrong passcode has been entered. • The Reverse Operation System (ROS) button (G) will blink when there is a fault with the Reverse Operation System. See "Reverse Operation System" in the Operation section of this manual. • After the first unsuccessful start attempt, the Battery Indicator Button (I) will blink for two (2) seconds and then stay lit. This indicates that the battery voltage is below normal operating level. While engine is in operation, this light may also indicate a charging system failure. • The Headlight Button (H) will blink when one or both of the headlight bulbs fail. • All indicator lights will blink in the event the engine shuts off for unknown reasons; for example, if the engine has run out of fuel. F EE CC TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 50) • Raise hood. • Unsnap headlight wire connector. • Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. • To replace, reverse above procedure. HOOD HEADLIGHT WIRE CONNECTOR 07002 Fig. 50 TRANSMISSION REMOVAL/REPLACEMENT Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See "PURGE TRANSMISSION" in the Operation section of this manual. ENGINE TO ADJUST THROTTLE CONTROL CABLE The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual. G I H Fig. 49 27