Husqvarna HU675FE Operation Manual - Page 16
Service And Adjustments
View all Husqvarna HU675FE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
SERVICE AND ADJUSTMENTS CAUTION: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: 1. Release control bar and stop engine. 2. Make sure the blade and all moving parts have completely stopped. 3. Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug. LAWN MOWER TO ADJUST CUTTING HEIGHT See "TO ADJUST CUTTING HEIGHT" in the Operation section of this manual. REAR DEFLECTOR The rear deflector, attached between the rear wheels of your mower, is provided to minimize the possibility that objects will be thrown out of the rear of the mower into the operator's mowing position. If the deflector becomes damaged, it should be replaced. TO REMOVE DRIVE BELT (See Figs. 19 and 20) 1. Remove drive cover and belt keeper. 2. Remove belt from gearcase pulley. 3. Turn lawn mower on its side with air filter and carburetor down. 4. Remove blade and blade adapter. 5. Remove belt from engine pulley. TO REPLACE DRIVE BELT (See Figs. 19 and 20) 1. Place new drive belt on engine pulley, inside tabs of belt retainer. 2. Route the other end of the new drive belt through hole in housing. 3. Reinstall blade adapter and blade. The recommended tightening torque is 35-40 ft. lbs. 4. Return mower to upright position. 5. Install new belt on gearcase pulley. 6. Reinstall belt keeper and drive cover. NOTE: Always use factory approved belt to assure proper fit and long life. DRIVE COVER BELT FIG. 19 BLADE ADAPTER BLADE LOCK WASHER KEY GEARCASE PULEY BELT KEEPER CRANKSHAFT KEYWAY BLADE HARDENED BOLT WASHER TRAILING EDGE CRANKSHAFT FIG. 20 BELT RETAINER 16