Husqvarna HU725AWD BBC Owners Manual - Page 5

To Assemble Grass Catcher, See Fig. 3, To Install Attachments, Install Starter Rope See Fig. 4

Get Husqvarna HU725AWD BBC PDF manuals and user guides View all Husqvarna HU725AWD BBC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

ASSEMBLY TO ASSEMBLE GRASS CATCHER (See Fig. 3) 1. Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top. 2. Slip vinyl bindings over frame. NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using. INSTALL STARTER ROPE (See Fig. 4) 1. Loosen T-knob. 2. Place throttle control in STOP position. 3. Slowly pull engine starter rope out until rope will slip into loop of rope guide. 4. Tighten T-knob. FRAME HANDLE THROTTLE CONTROL "STOP" POSITION VINYL BINDINGS FIG. 3 FRAME OPENING ROPE GUIDE T-KNOB ENGINE STARTER ROPE FIG. 4 TO INSTALL ATTACHMENTS Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see "TO CONVERT MOWER" in the Operation section of this manual. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
5
ASSEMBLY
TO ASSEMBLE GRASS CATCHER
(See Fig. 3)
1.
Put grass catcher frame into grass bag with rigid part
of bag on the bottom. Make sure the frame handle is
outside of the bag top.
2.
Slip vinyl bindings over frame.
NOTE
:
If vinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher.
To convert mower to bagging or discharging,
see “TO CONVERT MOWER” in the Operation section of
this manual.
FIG. 3
FRAME
HANDLE
VINYL
BINDINGS
FRAME
OPENING
INSTALL STARTER ROPE (See Fig. 4)
1. Loosen T-knob.
2.
Place throttle control in STOP position.
3.
Slowly pull engine starter rope out until rope will slip
into loop of rope guide.
4. Tighten T-knob.
FIG. 4
THROTTLE CONTROL
“STOP” POSITION
ENGINE
STARTER
ROPE
ROPE GUIDE
T-KNOB