Husqvarna HU725AWDH Owners Manual - Page 16
To Replace Drive Belt See Figs. 19 & 20
View all Husqvarna HU725AWDH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
SERVICE AND ADJUSTMENTS 5. Disconnect return spring from rear baffle / rear gearcase belt keeper. 6. Disconnect cable from rear gearcase. 7. Remove drive cover. 8. Remove front belt keeper. 9. Remove belt from front gearcase pulley. 10. Remove all three idler pulleys from idler assembly. 11. Remove belt from blade adapter/engine pulley and idler assembly. 12. Remove rear gearcase pulley by clamping locking pliars to input shaft (beneath pulley) and loosening pulley with a 9/16" box wrench. 13. Remove old belt from mower and discard. TO REPLACE DRIVE BELT (See Figs. 19 & 20) NOTE: Always use factory approved belt to assure proper fit and long life. 1. Place new belt on rear gearcase pulley. Be sure the new belt is inside the tabs of the belt keeper. 2. Reinstall rear gearcase pulley. 3. Route the other end of the new belt through hole in housing to front gearcase pulley. 4. Route new belt through idler assembly to blade adapter/ engine pulley. 5. Reinstall all three idler pulleys. 6. Position the blade adapter/engine pulley on the engine crankshaft. Be sure key in blade adapter/engine pulley and crankshaft keyway are aligned; and that the new belt is inside the tab of the belt retainer. 7. Install new belt on front gearcase pulley. 8. Reinstall front belt keeper. Be sure the new belt is inside the front belt keeper. 9. Reinstall drive cover. 10. Reattach cable to rear gearcase. 11. Reattach return spring to rear baffle / rear gearcase belt keeper. 12. Reinstall rear baffle. 13. Reinstall debris shield. 14. Reinstall blade. The recommended tightening torque is 35-40 ft. lbs. 15. Return mower to upright position. 16. Reattach spark plug wire to spark plug. REAR GEARCASE PULLEY INPUT SHAFT RETURN SPRING CABLE FRONT REAR GEARCASE BELT KEEPER BELT RETAINER BLADE ADAPTER / ENGINE PULLEY IDLER ASSEMBLY TABS BELT FRONT GEARCASE PULLEY FRONT BELT KEEPER CRANK- IDLER PULLEYS KEY SHAFT KEYWAY FIG. 20 16