Husqvarna HU775H Owners Manual - Page 5
Assembly - lawn mower
View all Husqvarna HU775H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY TO INSTALL ATTACHMENTS Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see "TO CONVERT MOWER" in the Operation section of this manual. TO REMOVE LAWN MOWER FROM CARTON 1. Remove loose parts included with mower. 2. Cut down two end corners of carton and lay end panel down flat. 3. Remove all packing materials except padding between upper and lower handle and padding holding operator presence control bar to upper handle. 4. Roll lawn mower out of carton and check carton thorougly for additional loose parts. 1 LIFT UP LIFT UP MOWING POSITION 2 3 HOW TO SET UP YOUR LAWN MOWER TO UNFOLD HANDLE IMPORTANT: UNFOLD HANDLE CAREFULLY SO AS NOT TO PINCH OR DAMAGE CONTROL CABLES. 1. Raise lower handle section to operating position and align hole in handle with one of three height positioning holes (Figure 3). 2. Insert handle bolt through handle and bracket and secure with knob (Figure 4). 3. Repeat for opposite side of handle. 4. Remove protective padding, raise upper handle section into place on lower handle and tighten both handle knobs. 5. Remove any packing material from around control bar. Your handles may be adjusted for your mowing comfort. Refer to "TO ADJUST HANDLE" in the Service and Adjustments section of this manual. 4 Figure 3 1. Operator presence control bar 2. Upper handle 3. Handle knob 4. Lower handle 2 1 3 Figure 4 1. Knob 2. Bolt 3. Handle bracket 5