Husqvarna HUV4421GX Owners Manual - Page 19
Key Switch – Gasoline Vehicles, Forward/Reverse Control, Accelerator Pedal
View all Husqvarna HUV4421GX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Controls and Indicators KEY SWITCH - GASOLINE VEHICLES The key switch (7) is mounted on the instrument panel to the right of the steering column (Figure 6). It has three positions: OFF, ON, and START. To start the vehicle, place the Forward/Reverse handle in the NEUTRAL position and turn the key to the START position, and hold it there until the engine starts. Activate the choke (14) as necessary. If the engine does not start after 10-15 seconds, release the key and repeat the procedure. Once the engine starts, release the key and it will return to the ON position. The engine will idle in neutral. The engine will continue to idle until the key is turned to the OFF position. See following WARNING, CAUTION, and NOTE. WARNING • Moving parts! Keep clear of the engine compartment while the engine is running. CAUTION • Do not shift the Forward/Reverse handle while the accelerator pedal is pressed. Shift the handle only when the vehicle is at a complete stop and the engine is at idle. Failure to heed this caution could result in damage to the transmission. NOTE: When the key is turned to the OFF position, the main vehicle systems are disabled. The key switch may be used as an emergency stop. The key can be removed only when the key switch is in the OFF position. KEY SWITCH - DIESEL VEHICLES The key switch (7) is mounted on the instrument panel to the right of the steering column (Figure 7). It has four positions: PREHEAT, OFF, ON, and START. Use the PREHEAT feature if the temperature falls below 23 °F (-5 °C). Do not hold the key in the PREHEAT position longer than 20 seconds. To preheat the glow plugs in cold weather, turn the key to the PREHEAT position, and hold it there for 10-15 seconds. Then turn the key to the START position, and hold it there until the engine starts. If the engine does not start after 10-15 seconds, turn the key to the OFF position and repeat the procedure. Once the engine starts, release the key and it will return to the ON position. The engine will idle in neutral. The engine will continue to idle until the key is turned to the OFF position. See previous WARNING, CAUTION, and NOTE. FORWARD/REVERSE CONTROL The Forward/Reverse handle (6) is located on the right side of the instrument panel (Figure 6 and Figure 7). The handle has three distinct positions: FORWARD (A), NEUTRAL (B), and REVERSE (C). Push the handle up to operate the vehicle in the forward direction, or pull the handle down to operate the vehicle in reverse. The engine can be started only when the handle is in the NEUTRAL (middle) position. The engine must be at idle before shifting the Forward/Reverse handle. See WARNING and CAUTION on page 15. This vehicle operates at a reduced speed in reverse. If equipped with a reverse buzzer, the reverse buzzer will sound as a warning when the Forward/Reverse handle is in the REVERSE position. ACCELERATOR PEDAL The accelerator pedal (1) is the pedal farthest to the right (Figure 6 and Figure 7). With the engine running and the Forward/Reverse handle in the FORWARD or REVERSE position, vehicle speed will increase as the accelerator pedal is pressed. When the accelerator pedal is released, it will return to the original position and the engine will idle. See WARNING and CAUTION on page 15. HUV 4421 Owner's Manual Page 17