Husqvarna K 1260 Owners Manual - Page 26
Adjustment of the cutting unit's, parallelism, Adjustment of Rider 850
View all Husqvarna K 1260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
MAINTENANCE Adjustment of the cutting unit's parallelism Adjustment of Rider 850 1. Dismantle the front hood and right-hand fender as described on page 18. 2. Vertical adjustment of the cutting unit is made with the adjusting nuts on the back edge of the lift-strut. 2 3. Raise the cutting unit at the front edge by shortening the lift-strut. Lower the cutting unit at the front edge by lengthening the lift-strut. 4. Tighten the nuts against each other after the adjustment. 5. On completion of the adjustment the unit's parallelism should be re-checked. Fit the right-hand fender and the front hood. Adjustment of Rider 970 1. Dismantle the front hood and right-hand fender as described on page 18. 2. Release the strut by pulling out the rear pin (1). Lift the rear edge of the hood to relieve the parallel strut. 3. Release the lock-nut (2). 4. Screw out the fork (3) to raise the front edge of the hood. Screw in the fork (3) to lower the rear edge of the hood. 5. Tighten the lock-nut after adjusting. 6. On completion of the adjustment the unit's parallelism should be re-checked. Fit the right-hand fender and the front hood. 1 32 24 - English