Husqvarna LE475 Owners Manual - Page 5
Assembly - replacement blade
View all Husqvarna LE475 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY TOOLS REQUIRED: 7/16" Wrench, Pliers, Screwdriver NOTE: Reference to Left or Right side of machine is from the operator's position of the handle, facing forward. The lawn edger, except the handle and throttle control, is fully assembled, packed, and shipped in one container. ATTACHING THE HANDLE 1. Remove handle brace, nuts, and bolts. Align the handle, lower support, and handle brace holes. Use all six nuts and bolts. Leave bolts loose until Steps 2 and 3 are completed (See Fig. 1). 2. Install control rod into upper and lower pivot holes and secure with cotter pins (See Fig. 1). Oil pivots lightly before installing rod. 3. Move clutch-depth lever into rear notch of quadrant on handlebards. Move cutterhead angling lever to top notch of quadrant. 4. Remove spark plug wire from spark plug. Move throttle to OFF position. Check clutch operation by pulling recoil starter rope. If blade turns when depth lever is in top notch, loosen handle bolts and pull toward operator. Snug bolts and check clutch operation again. - IMPORTANT NOTE - Make sure blade does not turn when lever is in top notch (disengaged). 5. Slip on the handle grips. 6. Tighten bolts. Throttle Cable Control Rod FILL ENGINE WITH OIL NOTE: There is no oil in engine crankcase. 1. Follow instructions in the engine manual for correct grade of oil, oil lling, and oil changing. 2. Do not mix oil with gasoline. INSTALLING THE THROTTLE WIRE 1. If the throttle cable is not attached to the engine carburetor, follow the instructions in the engine operating manual. Some throttle cables cannot be attached before shipping. Check oil level of engine every time edgertrimmer is used. An improper oil level can cause extensive internal damage to engine. FUEL SPECIFICATION 1. Follow fueling instruction in the engine manual. CAUTION Handlefuelwithcare-itishighly ammable. Use only approved fuel container. Never add fuel while engine is running. Fill fuel tank outdoors, with extreme care. Never ll fuel tank indoors. Replace gasoline cap securely and wipe up all spilled fuel. Always clean area around fuel cap before removing it to prevent excessive amounts of dirt from entering fuel system. Also insure that the fuel storage container you are using is clean and in good condition. CORRECT ENGINE OPERATION Install 6 Bolts Through Handle Lower Support & Handle Brace Holes Throttle Cable Clip Fig. 1 CAUTION Before starting engine, become familiar with all controls. Read this Operator's Manual thoroughly. Always check engine oil level before starting engine. WARNING Care should be taken to avoid inhaling exhaust gasses, as they contain carbon monoxide gas, which is colorless and oderless. Carbon monoxide is a dangerous gas that can cause unconsciousness and is potentially lethal. Do not run engine in con ned areas such as closed garages. 5