Husqvarna MZ 52LE Limited Edition Operation Manual - Page 29
Wheel and Deck Zerks, Engine oil change, Front Wheel Mount, Front Wheel Bearings, Deck Spindles
View all Husqvarna MZ 52LE Limited Edition manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
L U B R I C AT I O N Wheel and Deck Zerks Use only good quality bearing grease. Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality. Front Wheel Mount Lubricate 3-4 strokes with a grease gun on each set of wheel mounts. Front Wheel Bearings Lubricate 3-4 strokes with a grease gun on each set of wheel bearings. Engine oil change NOTE: Change the engine oil when the engine is warm. Refer to the engine owner's manual for the correct replacement oil and filter change recommendations. WARNING! To prevent burns, the engine should be shut off and allowed to cool slightly so the engine is still warm but the surrounding surfaces and oil are not. 1. Park on a level surface. Apply park brake. 2. Clean the dirt and debris from the area around the oil fill cap. 3. Remove the cap/dipstick. 4. Locate the drain hose at the left rear of the engine. Place an adequately sized container under the end of the drain hose and remove the oil drain plug. Deck Spindles Lower the cutting deck completely. If a grease gun without rubber hose is used, the foot plate must be removed to access the center spindle. Lubricate with a grease gun, 2-3 strokes per spindle. 5. Allow the oil to fully drain from the engine. 6. Replace the drain hose plug and tighten securely. 7. Fill the engine with new oil to the bottom of the fill tube threads. Check the level with the dipstick. 8. Replace the oil fill cap securely when the oil level is FULL. 9. Refer to the Service Journal for oil checking and changing intervals. 29