Husqvarna R 322T AWD Owners Manual - Page 23

Maintenance 2 Check the tension of the steering wires by squeezing them together by the arrows as illustrated. It should be possible to push them together so that the distance between them is half as much, without using unnecessary force. Adjusting the parking brake Rider 322T AWD Check that the parking brake is adjusted correctly by placing the machine on a slope with the front and rear axles disengaged. Apply and lock the parking brake. When the machine does not stand still, the parking brake should be adjusted according to the following. 1 Remove the left-hand wing cover. 3 If necessary, the wires can be adjusted by tightening the adjuster nuts on each side of the steering collar. Do not over tighten the cables; they should only be drawn in towards the steering collar. Hold the cable, for example using an adjustable wrench, so that it does not twist. If the adjustment is only made on one side, the middle position of the steering will be affected. Check the wire tension on completion of the adjustment as per item 2. Adjusting the parking brake Rider 220T The parking brake is adjusted as follows: 1 Loosen the locking nuts (1). 2 Tension the cable using the adjuster screw (2) until the play in the cable is taken up. 3 Tighten the locking nuts (1) after adjustment. 4 The parking brake should be checked again after the adjustment has been made. WARNING! A poorly adjusted parking brake ! can result in reduced braking ability. 2 Loosen the locking nuts (1). 3 Tension the cable using the adjuster screw (2) until the play in the cable is taken up. 4 Tighten the locking nuts (1). 5 The brake should be checked again after adjustment 6 Assemble the left-hand wing cover. Checking and adjusting of throttle wire Check that the engine responds to the throttle control and that the correct engine speed is achieved at full throttle. If doubts arise, contact your service representative. If adjustment is necessary, adjust the lower wire as follows: 1 Loosen the clamping screw for the cable's outer casing and move the throttle to the full throttle position. 2 Check that the throttle wire is attached to the correct hole in the lower lever, see diagram. 3 Pull the throttle wire casing to the far left and tighten the clamping screw. English - 23