Husqvarna ST 327P Owners Manual - Page 9
Meets A.n.s.i. Safety Requirements
View all Husqvarna ST 327P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
MUFFLER CHOKE CONTROL THROTTLE CONTROL ON/OFF SWITCH OPERATION POWER CORD GASOLINE PLUG FILLER CAP ELECTRIC START BUTTON AUGER CONTROL LEVER DISCHARGE CHUTE CONTROL LEVER DRIVE SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER PRIMER SAFETY IGNITION KEY FUEL SHUT-OFF VALVE CHUTE DEFLECTOR RECOIL STARTER HANDLE DISCHARGE CHUTE NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. CLEAN-OUT TOOL LIGHT TOOLBOX LH TURN TRIGGER TRACTION DRIVE CONTROL LEVER HANDLE KNOB MUFFLER AUGERS DRIFT CUTTER SKID PLATE FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage powerpropelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. LH and RH turn triggers - used to steer the snow thrower. Recoil (auxiliary) starter handle - used for starting the engine. Auger control lever - used to engage auger motion (throw snow). Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Discharge chute control lever - used to change the direction the snow is thrown. Choke control - used for starting a cold engine. ON / OFF switch - used to STOP the engine. Throttle- used to select FAST or SLOW engine speeds. Skid plate - used to adjust height of scraper bar from the ground. Drift cutter - used to cut through deep snowdrifts. 9