Husqvarna YT48CS Operation Manual - Page 21
Install Belt On Engine Clutch Pulley M
View all Husqvarna YT48CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
SERVICE AND ADJUSTMENTS 6. ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS (See Fig. 36) • Position front hole in side suspension arm (A) over pin on outside of tractor chassis and secure with large washer and large retainer spring (B). • Repeat on opposite side of tractor. • Insert other end of link (E) into hole in front mower bracket (H) and secure with washer and small retainer spring (J). NOTE: Requires deck lifting. FRONT LINK LOCATION B A D A. MOWER SIDE SUSPENSION ARMS B. RETAINER SPRING D. RIGHT SIDE REAR MOWER BRACKET Fig. 36 7. ATTACH REAR LIFT LINKS (C) (See Fig. 37) • Insert rod end of rear lift link (C) into hole (U) in tractor lift shaft suspension arm and pivot link down to mower. • Lift rear corner of mower and position slot in link as- sembly over pin on rear mower bracket (D) and secure with large washer and large retainer spring. • Repeat on opposite side of tractor. U C M F G E H J E. FRONT LIFT LINK ASSEMBLY F. FRONT SUSPENSION BRACKET G. LARGE RETAINER SPRING H. FRONT MOWER BRACKET J. SMALL RETAINER SPRING M. ENGINE CLUTCH PULLEY Fig. 38 9 INSTALL BELT ON ENGINE CLUTCH PULLEY (M) (See Fig. 27 & 39) • Disengage belt tension rod (K) from locking bracket (L). • Install belt onto engine clutch pulley (M). M M. ENGINE D CLUTCH PULLEY Fig. 39 C. REAR LIFT LINK(S) D. RIGHT SIDE REAR MOWER BRACKET U. HOLE Fig. 37 IMPORTANT: Check belt for proper routing in all mower pulley grooves and under mandrel covers. • Engage belt tension rod (K) on locking bracket (L). 8 ATTACH FRONT LINK (E) (See Fig. 38) • Turn steering wheel to position wheels straight forward. • From front of tractor, insert rod end of front link (E) through front hole in tractor front suspension bracket (F). • Move to left side of mower and and insert large retainer spring (G) through hole in front link (E) behind front suspension bracket (F). CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly. • Raise attachment lift lever to highest position. • If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual. 21