Husqvarna YTH24K54 Owners Manual - Page 24
To Replace Motion Drive Belt, See Fig. 39
View all Husqvarna YTH24K54 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
SERVICE AND ADJUSTMENTS TO REPLACE MOTION DRIVE BELT (See Fig. 39) Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest. BELT REMOVAL - • Remove mower (See "TO REMOVE MOWER" section in this manual). NOTE: Observe entire motion drive belt and position of all belt guides and keepers. • Disconnect clutch wire harness (A). • Remove anti-rotation link (B) on right side of tractor. • Remove belt from stationary idler (C) and clutching idler (D). • Remove belt from centerspan idler (E). • Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (F). • Remove belt downward from engine pulley and around electric clutch (G). • Slide belt toward rear of tractor, off the steering plate (H) and remove from tractor. BELT INSTALLATION - • Install new belt from tractor rear to front, over the steering plate (H) and above clutch brake pedal shaft (J). • Pull belt toward front of tractor and roll belt around electric clutch and onto engine pulley (G). • Pull belt toward rear of tractor. Carefully work belt down around transmission cooling fan and onto the input pulley (F). Be sure belt is inside the belt keeper. • Install belt on centerspan idler (E). • Install belt through stationary idler (C) and clutching idler (D). • Reinstall anti-rotation link (B) on right side of tractor. Tighten securely. • Reconnect clutch harness (A). • Make sure belt is in all pulley grooves and inside all belt guides and keepers. • Install mower (See "TO INSTALL MOWER" section in this manual). G B H A C J D E F Fig. 39 02953 electric 24