Husqvarna YTH24V42LS Owners Manual - Page 23
Engine, Transmission, To Remove Hood And Grill Assembly
View all Husqvarna YTH24V42LS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
SERVICE AND ADJUSTMENTS TO REMOVE CABLES, REVERSE ORDER • BLACK cable first from chassis and then from the fully charged battery. • RED cable last from both batteries. WEAK OR FULLY CHARGED DEAD BATTERY BATTERY Fig. 35 REPLACING BATTERY (See Fig. 36) INTERLOCKS AND RELAYS Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting. • Check wiring. TO REPLACE FUSE Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash. TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 37) • Raise hood. • Unsnap headlight wire connector. • Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. • To replace, reverse above procedure. WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding. • Lift hood to raised position. • Remove terminal cover. • Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor. • Install new battery with terminals in same position as old battery. • Reinstall terminal cover. • First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely. • Connect BLACK grounding cable to negative (-) battery terminal with remaining bolt and nut. Tighten securely • Close hood. HOOD HEADLIGHT WIRE CONNECTOR 07002 Fig. 37 TRANSMISSION REMOVAL/REPLACEMENT NEGATIVE (BLACK) CABLE Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See "PURGE TRANSMISSION" in the Operation section of this manual. TERMINAL COVER ENGINE TO ADJUST THROTTLE CONTROL CABLE The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- POSITIVE essary, see engine manual. (RED) CABLE TO ADJUST CHOKE CONTROL Fig. 36 The choke control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, TO REPLACE HEADLIGHT BULB see engne manual. • Raise hood. • Pull bulb holder out of the hole in the backside of the grill. • Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. TO ADJUST CARBURETOR Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair • Close hood. and/or adjustment. 23