IBM 2681 Hardware Maintenance Manual - Page 57
Symptom-to-FRU, index, Numeric, error, codes - service manual
UPC - 087944884422
View all IBM 2681 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Symptom-to-FRU index Symptom-to-FRU index The symptom-to-FRU index in this section lists symptoms and errors and their possible causes. The most likely cause is listed first, in boldface type. Note: Do the FRU replacement or other actions in the sequence shown in the column headed "FRU or action, in sequence." If replacing a FRU does not solve the problem, put the original part back in the computer. Do not replace a nondefective FRU. This index can also help you determine, during regular servicing, what FRUs are likely to need to be replaced next. A numeric error is displayed for each error detected in POST or system operation. In the displays, n can be any number. If no numeric code is displayed, check the narrative descriptions of symptoms. If the symptom is not described there, go to "Intermittent problems" on page 59. Note For an IBM device not supported by diagnostic codes in the ThinkPad notebook computers, see the manual for that device. Numeric error codes Symptom or error FRU or action, in sequence 0175 Bad CRC1, stop POST task-The EEPROM checksum is not correct. System board. 0176 System Security-The System has been tampered with. 1. Run IBM BIOS Setup Utility and Load Setup Defaults. 2. System board. 0177 System board. Bad SVP data, stop POST task. 0182 Bad CRC2. Enter BIOS Setup and load Setup Defaults. Run IBM BIOS Setup Utility and Load Setup Defaults. 0185 Bad startup sequence settings. Enter BIOS Setup and load setup defaults. Run IBM BIOS Setup Utility and Load Setup Defaults ThinkPad R40 53