IBM 87302RU Installation Guide - Page 100
Fibre-channel, switch, module, configuration, planning, Blade, server
View all IBM 87302RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
v Assign an operator key to each port. LACP can be used only if both stations sharing the link support the 802.3AD Link Aggregation Protocol. Fibre-channel switch module configuration planning You can install two fibre-channel switch modules in switch module bays 3 and 4 of the BladeCenter T unit. Each Fibre Channel switch module provides two external fibre-channel ports for connecting to storage devices and 14 internal fiber-channel ports that connect to the server blades in your the BladeCenter T unit. Internal ports run through 1 to 8 server blades. Internal ports 9 to 14 are not connected and do not need to be connected. Options that you can configure for the fibre-channel switch modules include: v Switch information v Ports v Network v Fabric Use the information provided in this section along with the worksheet provided (see "Fibre-channel switch module configuration planning" on page 112) to plan for the configuration of the Fibre-channel switch module. For detailed information about the fibre-channel switch module, see the BladeCenter Fibre-channel Switch Module Installation and User's Guide. The following Fibre-channel switch is supported: v IBM BladeCenter 2-port Fibre Channel Switch Module Make sure you are using the latest versions of device drivers, firmware, and BIOS for your blade server and management module. Go to the IBM Support Web site: www.ibm.com/pc/support for the latest information about upgrading the device drivers, firmware, and BIOS for BladeCenter components. The latest instructions are in the documentation that comes with the update. Blade server configuration planning Use the information provided in this section along with the worksheet provided (see "Management module configuration worksheet" on page 101) to plan for the configuration of the blade server. In addition, more information about the blade server is provided in the IBM BladeCenter HS20 Type 8832 Installation and User's Guide and IBM BladeCenter HS40 Type 8839 Installation and User's Guide. You can configure the following options for each blade server: v Enable or disable the IDE and Ethernet controllers. If you select disable, the system will not configure the disabled device, and the operating system will not detect the device (this is the equivalent of unplugging the device). v If you disable the on-board IDE controller and no other controller and the mass-storage device is installed, operating-system startup cannot occur. v Specify a system date and time. You can specify a time to be added or subtracted from the system time that is sent to the system-management processor each time that the blade server is started. If you want the system clock time to be the same as the system-management processor clock time, leave the value set at its default of 0. 86 BladeCenter T Types 8720 and 8730: Planning and Installation Guide