IBM 8840 User Guide - Page 15
Features, specifications - hyper v
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Features and specifications The following information is a summary of the features and specifications of the server. Depending on the server model, some features might not be available, or some specifications might not apply. Racks are marked in vertical increments of 1.75 inches. Each increment is referred to as a unit, or "U." A 1-U-high device is 1.75 inches tall. Table 1. Features and specifications Microprocessor: Hot-swap power supplies: Acoustical noise emissions: v Intel® Xeon 2.8 GHz or higher v Declared sound power, idle: 6.6 bel depending on server model 625 watts (100-240 V ac) v Declared sound power, operating: 6.6 bel v 800 MHz front-side bus (FSB) v Minimum: One v Support for up to two microprocessors v Maximum: Two - provide redundant Heat output: with Intel Hyper-Threading Technology Note: Use the Configuration/Setup Utility program to determine the type and speed of the microprocessors. Memory: v Minimum: 512 MB power Size (2 U): v Height: 85.4 mm (3.36 in.) v Depth: 702 mm (27.64 in.) v Width: 443.6 mm (17.5 in.) v Weight: approximately 21.09 kg (46.5 lb) to 29.03 kg (64 lb) depending upon Approximate heat output in British thermal units (Btu) per hour: v Minimum configuration: 1230 Btu (360 watts) v Maximum configuration: 2840 Btu (830 watts) v Maximum: 16 GB v Type: 2-way interleaved PC2-3200, ECC DDR II SDRAM, registered DIMMs only v Sizes: 256 MB, 512 MB, 1 GB, or 2 GB Drives: v Diskette: 1.44 MB v DVD-ROM: IDE Expansion bays: v Six hot-swap, 3.5-inch drive bays (hot-swap hard disk drives installed, some models) configuration Integrated functions: v Baseboard management controller v Two Broadcom 10/100/1000 Ethernet controllers (dual-port design) with Wake on LAN® support v One serial port v One external and one internal Ultra320 SCSI port (dual-channel controller with integrated RAID) v Three Universal Serial Bus (USB) v1.1 or v2.0 ports Electrical input: v Sine-wave input (50-60 Hz) required v Input voltage range automatically selected v Input voltage low range: - Minimum: 100 V ac - Maximum: 127 V ac v Input voltage high range: - Minimum: 200 V ac - Maximum: 240 V ac v Input kilovolt-amperes (kVA) approximately: - Minimum: 0.36 kVA - Maximum: 0.83 kVA v One 5.25-inch bay (DVD-ROM drive Note: The baseboard management installed) controller is also known as the service v One 3.5-inch removable-media drive bay processor. (diskette drive installed) Notes: 1. Power consumption and heat output vary depending on the number and type Expansion slots: v Two PCI-X non-hot-plug 100 MHz/64-bit (low profile) v Two PCI-X non-hot-plug 133 MHz/64-bit Video controller: v ATI Radeon 7000M IGP video on system board v Compatible with SVGA and VGA v 16 MB DDR-SDRAM video memory of optional features installed and the power-management optional features in use. 2. These levels were measured in controlled acoustical environments Hot-swap fans: v Standard: Six v Maximum: 12 - provide redundant cooling Environment: v Air temperature: - Server on: 10° to 35°C (50.0° to 95.0°F); altitude: 0 to 914.4 m (3000 according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a ft) Decrease system temperature by given location might exceed the average 0.75°C for every 1000 feet increase values stated because of room in altitude. reflections and other nearby noise - Server off: 10° to 43°C (50.0° to sources. The declared sound-power 109.4°F); maximum altitude: 2133 m levels indicate an upper limit, below (7000 ft) which a large number of computers will - Shipment: -40° to 60°C (-40° to operate. 140°F); maximum altitude: 2133 m (7000 ft) v Humidity: - Server on/off: 8% to 80% - Shipment: 5% to 100% Chapter 1. Introducing the IBM xSeries 346 Type 8840 3