IBM DBCA-204860 Hard Drive Specifications - Page 68
Alternate Status Register, Command Register, Cylinder High Register, Cylinder Low Register
View all IBM DBCA-204860 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
9.1 Alternate Status Register Alternate Status Register 7 6 5 BSY RDY DF 4 3 2 1 0 DSC DRQ COR IDX ERR Figure 39. Alternate Status Register This register contains the same information as the Status Register. The only difference is that reading this register does not imply interrupt acknowledge or clear a pending interrupt. See 9.13, "Status Register" on page 63 for the definition of the bits in this register. 9.2 Command Register This register contains the command code being sent to the device. Command execution begins immediately after this register is written. The command set is shown in Figure 56 on page 95. All other registers required for the command must be set up before writing the Command Register. 9.3 Cylinder High Register This register contains the high order bits of the starting cylinder address for any disk access. At the end of the command, this register is updated to reflect the current cylinder number. In LBA Mode this register contains Bits 16-23. At the end of the command, this register is updated to reflect the current LBA Bits 16-23. The cylinder number may be from zero to the number of cylinders minus one. 9.4 Cylinder Low Register This register contains the low order 8 bits of the starting cylinder address for any disk access. At the end of the command, this register is updated to reflect the current cylinder number. In LBA Mode this register contains Bits 8-15. At the end of the command, this register is updated to reflect the current LBA Bits 8-15. The cylinder number may be from zero to the number of cylinders minus one. 60 OEM Specifications of DBCA-2xxxxx 2.5 inch H D D