IBM T43P Hardware Maintenance Manual - Page 141
Important, Diagnostics, Other, Devices, Active, Protection, Attention
UPC - 890552631513
View all IBM T43P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
Removing and replacing a FRU Important When handling the system board, bear the following in mind. v The system board has an accelerometer, which can be broken by applying several thousands of G-forces. Note: Dropping a system board from a height of as little as 6 inches so that it falls flat on a hard bench can subject the accelerometer to as much as 6,000 G's of shock. v Be careful not to drop the system board on a bench top that has a hard surface, such as metal, wood, or composite. v If a system board is dropped, you must test it, using PC-Doctor for DOS, to make sure that the HDD Active Protection still functions (see below). Note: If the test shows that HDD Active Protection is not functioning, be sure to document the drop in any reject report, and replace the system board. v Avoid rough handling of any kind. v At every point in the process, be sure not to drop or stack the system board. v If you put a system board down, be sure to put it only on a padded surface such as an ESD mat or conductive corrugated material. After replacing the system board, run PC-Doctor for DOS to make sure that HDD Active Protection still functions. The procedure is as follows: 1. Place the computer on a horizontal surface. 2. Run Diagnostics --> Other Devices --> HDD Active Protection Test. Attention: Do not apply physical shock to the computer while the test is running. ThinkPad T43/T43p Series 135