IBM x3105 Installation Guide - Page 54
codes, error
UPC - 000435950734
View all IBM x3105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
POST beep codes POST emits one beep to signal successful completion. If POST detects a problem during startup, other beep codes might occur. Use the following beep code descriptions to help diagnose and solve problems that are detected during startup. Note: See the Problem Determination and Service Guide on the IBM System x Documentation CD for more information about the POST beep codes. Repeating long beeps A memory error has occurred. Make sure that all DIMMs are correctly installed. For additional information, see beep code 3-3-3 in the Problem Determination and Service Guide on the IBM System x Documentation CD. Other beep codes See the Problem Determination and Service Guide on the IBM System x Documentation CD for information about other beep codes. POST error codes The following table provides an abbreviated list of the error codes that might appear during POST. See the Problem Determination and Service Guide on the IBM System x Documentation CD for more information about the POST error codes. To check for updated technical information, go to http://www.ibm.com/servers/eserver/ support/xseries/index.html, select System x3105, and click Go; then, click the Install and use tab and click Product documentation. v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See the parts listing in the Problem Determination and Service Guide to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician. Error code Description Action 062 The server failed to start on three 1. Update the system firmware to the latest level. consecutive boots using the default configuration. 2. (Trained service technician only) Replace the system board. 101, 102 A tick timer internal interrupt, internal timer (Trained service technician only) Replace the system channel 2 error occurred. board. 106 A diskette controller failure occurred. 1. Make sure that the Configuration/Setup Utility program correctly reflects the type of diskette drive. 2. Reseat the following components: a. Diskette drive cable b. Diskette drive 3. Replace the following components one at a time in the order shown, restarting the server each time: a. Diskette drive cable b. Diskette drive c. (Trained service technician only) System board 40 System x3105 Type 4347: Installation Guide