IC Realtime AVR-1404 Product Manual - Page 151

Please refer to the following sheet for log parameter information. Parameter Function Device search Add Modify Click Device search button, you can view the searched device information on the list. It includes device IP address, port, device name, manufacturer and type. Select a device in the list and then click Add button, system can connect the device automatically and add it to the Added device list. Or you can double click one item in the list to add a device. Click or any device in the Added device list, you can change the Delete corresponding channel setup. Click , you can delete the remote connection of the corresponding Connection status channel. : Connection succeeded. : Connection failed. Delete Manual Add Select a device in the Added device list and then click Delete button, system can disconnect the device and remove it from the Added device list. Click it, the interface is shown as in Figure 5-16. Here you can add network camera manually. You can select a channel from the dropdown list (Here only shows disconnection channel.) Note:  System supports manufactures such as Panasonic, Sony, Dynacolor, Samsung, AXIS, Arecont, Dahua and Onvif standard protocol.  If you do not input IP address here. System uses default IP 192.168.0.0 and system does not connect to this IP.  Can not add two devices at the same time. Click OK button here, system only connect to the corresponding device of current channel. 5.8.1.2 Conditions Here you can view device property information. The setups become valid immediately after you set. The analog channel is shown as in Figure 5-17. 142