IC Realtime AVS-1816 Product Manual - Page 184
Multicast, Auto Register,
View all IC Realtime AVS-1816 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
Parameter Trap address Trap port SNMP version Function and one group of the managers. Please make sure the device and the proxy are the same. The read community will read/write/access all the objects the SNMP supported in the specified name. The default setup is write. The destination address of the Trap information from the proxy program of the device. The destination port of the Trap information from the proxy program of the device. It is for the gateway device and the client-end PC in the LAN to exchange the information. It is a non-protocol connection port. It has no effect on the network applications. It is a UDP port not TCP port. The value ranges from 1 to 165535. The default value is 162. Check V1, system only processes the information of V1. Check V2, system only processes the information of V2. 5.8.2.12 Multicast The multicast interface is shown as in Figure 5-34. Multicast is a transmission mode of data packet. When there is multiple-host to receive the same data packet, multiple-cast is the best option to reduce the broad width and the CPU load. The source host can just send out one data to transit. This function also depends on the relationship of the group member and group of the outer. Figure 5-34 5.8.2.13 Auto Register The auto register interface is shown as below. See Figure 5-35. This function allows the device to auto register to the proxy you specified. In this way, you can use the client-end to access the DVR and etc via the proxy. Here the proxy has a switch function. In the network service, device supports the server address of IPv4 or domain. Please follow the steps listed below to use this function. Please set proxy server address, port, and sub-device name at the device-end. Please enable the auto register function, the device can auto register to the proxy server. Figure 5-35 175