IC Realtime EL-1000B Product Manual - Page 9

Troubleshooting, Dimension mm, Specification

Page 9 highlights

9. Troubleshooting Problems Troubleshooting 34DPNNVOJDBUJPOGBJMT ·1MFBTFDIFDLUIFQPMBSJUZCFUXFFO34$POUSPM 1PSUBOE34DBCMF $POUSPM#PBSE$POOFDUJPO1PSU $0//&$5*0/5&3.*/"- 539  $0//&$5*0/5&3.*/"- 539 34$POUSPM1PSU   ·1MFBTFDIFDLJGUIFJOJUJBMWBMVFPGUIF34 $PNNVOJDBUJPOTFUVQNBUDIFTCFUXFFODBNFSBBOE 04%$POUSPMMFSPS%73 34$PNNVOJDBUJPOFTUBCMJTINFOUJOJUJBMWBMVF *UFN $BNFSB*% #"6%3"5& 6"35.0%& 3&51,5 *OJUJBMWBMVF   /0/& &/"#-& ·8FSFDPNNFOEUIBUZPVNBLFHSPVOEDPOOFDUJPO CFUXFFODBNFSBBOEDPOUSPMMFSGPSTBGFDPNNVOJDBUJPO DPOUSPM · 8IFO34DBCMFJTOPUQSPQFSMZDPOOFDUFE 1MFBTFSFDPOOFDUBOE3FCPPUsJTEJTQMBZFE5IFOQMFBTF UVSOPGGUIFQPXFSBOEDPOOFDUUIFDBCMFBHBJO 10. Dimension (mm) ʡ    ʡ  16    11. Specification Model Image sensor Effective Pixels H.Resolution Synchronization Video output S/N Ratio Min.Illumination Shutter speed Gamma control EL-1000 (I-Sniper) 1/3" Pixim WDR digital imaging device 410,000 pixels 758(H)X540(V) 690HTVL effective. Internal 1.0Vp-p Composite 75 Ohms 50dB(AGC OFF, Weight ON) 0Lux 1/25s ~ 1/30,720s(Global Shutter) 6WDQGDUGȖ  White Balance 2000°K ~ 11,000°K Auto. ATW / AWB selectable by OSD Power source DC12V Operating current 150mA / DC12V(IR Off), 360mA(IR On) LENS 2.8~12mm Varifocal lens(F1.4) IR spectrum 850nm Viewable distance Up to 75ft at moonless night Iris control DC MTBF of IR 20,000 hours Operation Temperature -10୅Gto +50୅ Humidity 0% to 90% RH Measurement(mm) 88(W) x 88(H) x 253.7(D) Weight(Approx.g) 1,000 Function WDR Low / Normal / Middle / High AGC Low / Normal / High BLC On/Off Fluorescent Off / CRR / CRR2 ICR DVR Tool Off / EDGE / MAX / FLEX / ELITE RS485 Pelco-D Flip Off / Horiz / Vert / Both 4QFDJGJDBUJPOTBSFTVCKFDUUPDIBOHFXJUIPVUQSJPSOPUJDFGPSJNQSPWFNFOU 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

16
17
9. Troubleshooting
10. Dimension (mm)
11. Specification
Problems
Troubleshooting
RS-485 communication fails.
·
Please check the polarity between RS-485 Control
Port and RS-485 cable.
·
Please check if the initial value of the RS-485
Communication setup matches between camera and
OSD Controller or DVR.
·
We recommend that you make ground connection
between camera and controller for safe communication
control.
485 Control Board Connection Port
RS-485 Control Port
(+)CONNECTION TERMINAL(TRX+)
485+
(-)CONNECTION TERMINAL(TRX-)
485-
UART MODE
RET PKT
Item
Camera ID
BAUD RATE
Initial value
1
9600
8-NONE-1
ENABLE
* RS-485 Communication establishment initial value
·
When RS-485 cable is not properly connected,
Please reconnect and Reboot’ is displayed.Then please
turn off the power and connect the cable again.
74.8
83.2
Ø74
107.3
Ø88
74.8
39.7
120.2
19
* Specifications are subject to change without prior notice for improvement.
BLC
Fluorescent
Off / CRR / CRR2
ICR DVR Tool
Off / EDGE / MAX / FLEX / ELITE
RS485
Pelco-D
150mA / DC12V(IR Off), 360mA(IR On)
MTBF of IR
20,000 hours
Humidity
0% to 90% RH
AGC
Low / Normal / High
WDR
Low / Normal / Middle / High
Power source
DC12V
Function
Flip
Off / Horiz / Vert / Both
Operating current
Up to 75ft at moonless night
Operation Temperature
-10
to +50
Iris control
DC
LENS
2.8~12mm Varifocal lens(F1.4)
On/Off
Measurement(mm)
88(W) x 88(H) x 253.7(D)
Weight(Approx.g)
1,000
2000°K ~ 11,000°K Auto. ATW / AWB selectable by OSD
White Balance
IR spectrum
850nm
Viewable distance
H.Resolution
690HTVL effective.
Synchronization
Internal
Video output
1.0Vp-p Composite 75 Ohms
Gamma control
S/N Ratio
50dB(AGC OFF, Weight ON)
Min.Illumination
0Lux
Shutter speed
1/25s ~ 1/30,720s(Global Shutter)
Image sensor
1/3" Pixim WDR digital imaging device
Effective Pixels
410,000 pixels 758(H)X540(V)
Model
EL-1000 (I-Sniper)