IC Realtime ICIP-D2000VIR Product Manual - Page 18
Installation
View all IC Realtime ICIP-D2000VIR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
3 Installation Important Before you complete the installation and setup, do not remove the electrostatic attraction film on the transparent enclosure. Otherwise it may result in injury. After remove electrostatic attraction film, do not touch dome enclosure in case it may leave stain. Before the installation, please make sure the installation surface can sustain at least 3X weight of the bracket and the camera. 3.1 Device Installation Introduction Please refer to Figure 3-1 for device installation space information. You can use screws (diameter is less than 4.5mm) to secure the device. You can see there are installation position map and installation screws in the accessories bag for you to install the device conveniently. Figure 3-1 Installation 1 3.2 Device Installation Steps 3.2.1 General Installation The general interface is shown as in Figure 3-2. 12