IC Realtime ICIP-D5000VIR Product Manual - Page 16
Alarm Setup
View all IC Realtime ICIP-D5000VIR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Listening Operation At the PC-end, speak via the speaker or the pickup, and then you can get the audio from the earphone or sound box at the device-end. 2.4 Alarm Setup The alarm interface is shown as in Figure 2-12. Please follow the steps listed below for local alarm input and output connection. 1) Connect the alarm input device to the alarm input port (No.4 pin) of the I/O cable. 2) Connect the alarm output device to the alarm output port (No.1 pin) and alarm output public port (No.2 pin). The alarm output port supports NO (normal open) alarm device only. 3) Open the Web, go to the Figure 2-12. Please set the alarm input 01 port for the first channel of the I/O cable (No.4 pin). Then you can select the corresponding type (NO/NC.) 4) Set the WEB alarm output. The alarm output 01 is for the alarm output port of the device. It is the No.1 pin of the I/O cable. Figure 2-12 Alarm Please refer to the following figure for alarm input information. See Figure 2-13. Alarm input: When the input signal is idle or grounded, the device can collect the different statuses of the alarm input port. When the input signal is connected to the 5V or is idle, the device collects the logic "1". When the input signal is grounded, the device collects the logic "0". Figure 2-13 Alarm input 11