Icom IC-705 Instructions 1 - Page 5

Setting up from a PC using a USB cable To setup from a PC using a USB cable, follow the steps described below. Step 1 Connecting the transceiver and PC using a USB cable Step 2 Making an Initial setup Step 3 Reading the settings from the transceiver (p. 6) Step 4 Editing the parameters (p. 6) Step 5 Writing the setting data to the transceiver (p. 6) Step 1 Connecting the transceiver and PC using a USB cable 1. Install the USB driver. LLThe latest USB driver and "USB Driver Installation Guide" can be downloaded from the Icom website. 2. Turn OFF the transceiver. 3. Connect the USB cable, as shown below. 4. Turn ON the transceiver. PC Transceiver (Right side panel) USB cable To a USB port USB Type-A or Type-C USB Micro-B To the [microUSB] port Step 2 Making an Initial setup When you start the CS-705, the Initial Setup window is displayed. Before using the software, follow the steps below to make a initial setup to send the transceiver version information. 1. Click the "COM Port" radio button. 2. Click to display the IC-705 Search window. Select the appropriate transceiver and click . •• The COM port number will be set in the input field. 3. Click to open the programming screen. NOTE: •• When the transceiver version information is not correctly sent to the software, some items may not be displayed on the software. •• If you want to make the initial setup again, select "CS-705 Initial Setup" in the Windows Start menu. ((Windows logo) > START > CS-705 > CS-705 Initial Setup) 1 Click 2 Click and select a port 3 Click 5