Icom IC-7100 Advanced Instructions - Page 69

Previous view 4 RECEIVE AND TRANSMIT Operating CW (Continued) DDAbout the CW reverse mode The CW reverse mode receives signals with a reverse side CW carrier point similar to voice LSB and USB modes. Use when interfering signals are near a desired signal and you want to reduce the interfering tone. qqOn the Mode selection screen, touch "CW" to select the CW mode. wwAfter the CW mode is selected, touch "CW" again on the Mode selection screen to toggle between CW and CW-R modes. • Check that the interfering tone can be reduced. Carrier point The CW carrier point is set to the LSB side by default, the setting can be changed to USB side in the "CW Normal Side" item of the "Function" Set mode. (p. 17-21) SET(C) > Function > CW Normal Side BFO Interference Desired signal CW mode (LSB side) BFO Interference Desired signal CW-R mode (USB side) Left Display Center Right The L, R, C or D in the instructions indicate the part of the controller. L: Left side R: Right side C: Center bottom D: Display (Touch screen) DD About keying speed The transceiver's internal electronic keyer speed can be adjusted to between 6 and 48 wpm (words per minute). qqPush SPEED/PITCH (C) to open the Key speed/CW pitch adjustment display. wwRotate [M-CH] (L) clockwise to increase keying speed; counterclockwise to decrease it. eePush MENU (C) to close the display. DDAbout CW pitch control The received CW audio pitch can be adjusted to suit your preference without changing the operating frequency. qqPush SPEED/PITCH (C) to open the Key speed/CW pitch adjustment display. wwRotate [BANK] (L) to suit your preference. • Adjustable from 300 to 900 Hz (in 5 Hz steps). eePush MENU (C) to close the display. Key speed adjustment CW pitch adjustment 4-4