Icom IC-F1100D Instructions - Page 2

PANEL DESCRIPTION There are 3 types of transceivers in the IC-F1100D and IC-F2100D series. ••IC-F1100D / IC-F2100D: Non-display type ••IC-F1100DS / IC-F2100DS: Simple key type ••IC-F1100DT / IC-F2100DT: Ten-key type The illustration below shows the Ten-key type transceiver. Antenna connector Status indicator [PTT] [Up]*1,2 [Upper]*1,4 [Down]*1,2 [Lower]*1,4 [Rotary Selector]*1 [VOL] [Emer]*1 Speaker Speaker microphone jack Microphone Function Display*2 [P0],[P1], [P2],[P3]*1, 2 Ten-key*1, 3 *1: Dealer assignable. *2: Only for the Simple key and Ten-key types. *3: Only for the Ten-key type. *4: Only for the Non-Display type. DDStatus indicator Lights red: Transmitting. Lights green: Receiving or squelch is open. Lights or blinks orange: A matching signal is received, depending on the presetting. Slowly blinks green: The battery should be charged. Blinks green fast: The battery must be charged. DDSpeaker microphone jack CAUTION: DO NOT use the transceiver without the jack cover or the optional equipment attached. The transceiver meets IP67 requirements for dust-tight and waterproof protection only when the jack cover or the optional HM-222HLWP, HS-94LWP, or HS-95LWP is attached. DDFunction display (For only the Simple key and Ten-key types) 1 2 34 5 6 7 8 9 10 11 1 SIGNAL STRENGTH INDICATOR Displays the relative receive signal strength level. 2 LOW POWER ICON Displayed when low output power is selected. 3 AUDIBLE ICON •• Displayed when the channel is in the 'Audible' (unmuted) mode. •• Displayed when a matched 2-Tone or 5-Tone is received. •• For the dPMR models: Displayed when a Call Setup is received (Digital mode). 4 GPS ICON Displayed when the GPS signal is received, depending on the presetting. 5 ENCRYPTION / SCRAMBLER ICON For the NXDN models: Displayed when the Encryption function is ON. For the dPMR models: D isplayed when the Scrambler function is ON. 6 BELL ICON Displayed or blinks when a matching signal is received, depending on the presetting. 7 SCAN ICON Displayed or blinks while scanning. 8 KEY LOCK ICON Displayed when the Key Lock function is ON. 9 BATTERY INDICATOR •• Displays the remaining battery charge. •• Blinks when the battery charge decreases to a set level. Indication Battery Status Full Mid Charging Battery required exhausted 10 ALPHANUMERIC READOUT Displays messages such as channel text. 11 SHIFT INDICATOR Displayed when [Shift] is pushed. BATTERY CHARGING NOTE: Before detaching or attaching a battery pack, BE SURE to turn OFF the transceiver by rotating [VOL] fully counter clockwise, until it makes a "click" sound. Otherwise, a transceiver malfunction could occur. DDRapid charging with the BC-213 You can rapidly charge the Li-ion battery pack with the BC-213. Charging time: Approximately 3.5 hours for the BP-280 Additionally needed item (purchase separately): ••A power adapter (may be supplied with the charger, depending on the charger version). Power adapter* Battery pack + Transceiver Battery pack Turn OFF DDRapid charging with the BC-214 You can rapidly and simultaneously charge up to 6 battery packs with the optional BC-214 (the AD-130 CHARGER ADAPTERS are installed.) Charging time: Approximately 3.5 hours for the BP-280 Additionally needed item (purchase separately): ••The BC-157S AC ADAPTER or the OPC-656 DC POWER CABLE CAUTION: DO NOT reverse the polarity when connecting the OPC-656 to a power source. This will ruin the battery charger. Red: +, Black: _ Battery pack Battery pack + Transceiver Turn OFF To an AC outlet Power adapter*2 BC-213 Charging indicator Lights orange: Charging Lights green: Charged The CP-23L (for a 12 V cigarette lighter socket) can be used instead of the power adapter. * A different type, or no power adapter is supplied, depending on the charger version. NOTE: If the charging indicator alternately blinks green and orange, remove the battery pack or the transceiver from the charger, then reinsert it. BC-214 Charger adapter*1 OPC-656 Connect to a DC power supply: 12 to 16 V, at least 7 A Red: +, Black: _ *1: C harger adapter's shape may differ, depending on the charger version. *2: A different type, or no power adapter is supplied, depending on the charger version. NOTE: The BC-214 has a charging timer that stops charging after approximately 5.3 hours of charging. BASIC OPERATION DDTurning ON the transceiver NOTE: Before using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. See the BATTERY CHARGING section. zz Rotate [VOL] to turn ON the transceiver. DDReceiving and Transmitting Receiving: 1. Select a channel. LLRotate [Rotary Selector] or push [CH Up] or [CH Down], depending on the presetting. 2. When receiving a call, rotate [VOL] to adjust the audio output level to a comfortable listening level. NOTE: Depending on the presetting, the transceiver may automatically transmit the microphone audio for the preset time period when a matching signal is received. (Auto TX function) Transmitting: CAUTION: DO NOT transmit without an antenna. 1. Wait until the channel is clear to avoid interference. 2. Hold down [PTT] to transmit. 3. Release [PTT] to receive. IMPORTANT: To maximize the readability of your signal: 1. After pushing [PTT], pause briefly before you start speaking. 2. Hold the microphone 5 to 10 cm (2 to 4 inches) from your mouth, then speak at your normal voice level. DDKey Lock function You can use the Key Lock function to prevent accidental channel changes and unnecessary function access, depending on the presetting. All assignable keys except the following are electronically locked: [Monitor], [Call], [Call A], [Call B], [Emergency], [Light], [Lock], [Lone Worker], [Siren], [Surveillance], [Sp. Func 1], [Sp. Func 2], [Shift], [Clear]*, and [PTT]. * : For only the dPMR models. You can also make or receive calls, or turn the transceiver ON or OFF, during the Key Lock function is ON. zz Hold down [Lock] for 1 second to turn the Key Lock function ON or OFF. For only the Simple-key and Ten-key types is displayed when the Key Lock function is ON disappears when the Key Lock function is OFF. DDAquaQuakeTM Water Draining function If the [AquaQuake] is assigned to a key, the AquaQuake Water Draining function clears water from the speaker grill to maintain clear audio by vibrating the speaker cone. 1. Hold down [AquaQuake] to turn ON the AquaQuake water draining function. •• A low frequency vibration is generating to remove water from the speaker grill. •• Water in the speaker grill may muffle the sound coming from the speaker. 2. Release the key to turn OFF the function. NOTE: ••After the specified period of time expires, this function automatically stops, even if a user continues to hold down this key. ••This key works for only the internal speaker. OPTIONS DDBATTERY PACKS ••BP-278/BP-279/BP-280 BATTERY PACKS For IC-F1100D series, Output Power 5 W/ IC-F2100D series, Output Power 4 W: Battery pack Voltage Capacity Approximate battery life* BP-278 7.2 V 1130 mAh (minimum) 1190 mAh (typical) 9 hours BP-279 7.2 V 1485 mAh (minimum) 1570 mAh (typical) 11.5 hours BP-280 7.2 V 2280 mAh (minimum) 2400 mhA (typical) 18 hours For IC-F2100D series, Output Power 5 W: Battery pack Voltage Capacity Approximate battery life* BP-278 7.2 V 1130 mAh (minimum) 1190 mAh (typical) 8.5 hours BP-279 7.2 V 1485 mAh (minimum) 1570 mAh (typical) 11 hours BP-280 7.2 V 2280 mAh (minimum) 2400 mAh (typical) 17 hours * W hen the power save function is turned ON, and the operating periods are calculated under the following conditions. TX : RX : standby = 5 : 5 : 90 DDCHARGERS ••BC-213 DESKTOP CHARGER To rapidly charge a single battery pack. A power adapter may be supplied, depending on the charger version. ••BC-214 MULTI CHARGER + BC-157S AC ADAPTER To rapidly charge up to 6 battery packs. DDDC CABLES ••CP-23L CIGARETTE LIGHTER CABLE Use when charging the battery pack from a 12 V cigarette lighter socket. (Use with the BC-213) ••OPC-656 DC POWER SOCKET Use with a 13.8 V power source instead of the power adapter. (Use with the BC-214) DDANTENNAS ••FA-SC25V/FA-SC28V/FA-SC29V/FA-SC55V VHF ANTENNAS FA-SC25V: 136-150 MHz FA-SC28V: 148-162 MHz FA-SC29V: 160-174 MHz FA-SC55V: 150-174 MHz •• FA-SC26VS/FA-SC27VS/FA-SC56VS/FA-SC57VS VHF STUBBY ANTENNAS FA-SC26VS: 136-144 MHz FA-SC27VS: 142-150 MHz FA-SC56VS: 150-162 MHz FA-SC57VS: 160-174 MHz ••FA-SC61VC VHF CUT ANTENNA FA-SC61VC: 136-174 MHz ••FA-SC25U/FA-SC57U/FA-SC72U/FA-SC73US UHF ANTENNAS FA-SC25U: 400-430 MHz FA-SC57U: 430-470 MHz FA-SC72U: 470-520 MHz FA-SC73US: 450-490 MHz ••FA-SC26US UHF STUBBY ANTENNAS FA-SC26US: 400-450 MHz ••FA-SC01U/FA-SC02U UHF ANTENNAS FA-SC01U: 350-400 MHz FA-SC02U: 330-380 MHz ••FA-SC61UC UHF CUT ANTENNAS FA-SC61UC: 380-520 MHz DDOTHERS ••MB-130 CHARGER BRACKET Mounts the BC-213 desktop charger on a variety of places in a vehicle. ••MB-133 BELT CLIP •• HM-158LA/HM-159LA/HM-222HLWP* SPEAKER MICROPHONE Combination speaker-microphone that provides convenient operation while the transceiver is hanging on your belt. LLAdjust the microphone gain before use. *High audio output is only usable with transceivers that support the function. (With a "U" mark on the serial number label) ••HM-153LA/HM-166LA EARPHONE MICROPHONE Ideal for hands-free operation. Clip the HM-153LA or HM-166LA (with integrated PTT switch) to your lapel or breast pocket. LLAdjust the microphone gain before use. ••HS-94/HS-95/HS-97 HEADSET + VS-4LA PTT SWITCH CABLE/ OPC-2004LA ADAPTER CABLE HS-94: Ear-hook type HS-95: Neck-arm type HS-97: Throat microphone VS-4LA: To connect to headsets OPC-2004LA: To connect to headsets for VOX operation LLAdjust the both microphone and VOX gain before use. ••HS-94LWP/HS-95LWP HEADSET HS-94LWP: Ear-hook type HS-95LWP: Neck-arm type LLAdjust the both microphone and VOX gain before use. Some options may not be available in some countries. Ask your dealer for details.