Icom IC-F3261D Instructions - Page 2

PANEL DESCRIPTION There are 2 types of transceivers in the IC-F3260 and IC-F4260 series. IC-F3260DS / IC-F4260DS: IC-F3260DT / IC-F4260DT: Simple key type Ten-key type The illustration below shows the Ten-key type transceiver. [Rotary Selector] Antenna connector [Emer]*2 [Side1]*2 [PTT] [Side2]*2 [Side3]*2 [VOL] GPS receiver *1 Status indicator Speaker Multi-connector Microphone Function display [P0]*2, [P1]*2, [P2]*2, [P3]*2 Ten-key pad *1 Built in, depending on the transceiver version. *2 Dealer assignable DDAbout the Status indicator •• Lights red while transmitting. •• Lights green while receiving a signal, or when the squelch is open. •• Blinks red when the battery is exhausted. DDAbout the Multi-connector Connects to an optional speaker microphone or headset. CAUTION: BE SURE to attach the connector cover when an optional accessory is not used. The transceiver meets IP67 requirements for dust-tight and waterproof protection only when the connector cover or the optional HM-184/HM-184H is attached. DDFUNCTION DISPLAY 1 2 3 4 56 7 8 9 CALA TXCU TXC SET 10 1 SIGNAL STRENGTH ICON Displays the relative receive signal strength. 2 LOW POWER ICON Displayed when low output power is selected. LLWhen the battery charge decreases to a specified level, low power is automatically selected. 3 AUDIBLE ICON •• Displayed when the channel is in the audible (unmuted) mode. •• Displayed when a matching signal is received. 4 COMPANDER ICON Displayed when the Compander function is ON. 5 SCRAMBLER ICON Displayed when the Voice Scrambler function is ON. 6 BELL ICON Displayed when a matching signal is received, depending on the presetting. 7 CALL CODE MEMORY ICON Displayed when the call code memory is selected. 8 BATTERY ICON Displays the battery level. Indication Battery Status Full Mid Charging Battery required exhausted L L blinks when the battery is exhausted. 9 ALPHANUMERIC DISPLAY •• Displays the operating channel number, channel name, Set mode contents, DTMF code, and so on. •• Depending on the presetting, characters are displayed in 1 line or 2 lines on the display. LLIn this instruction sheet illustration, characters are displayed in 2 lines. 10 KEY ICONS Displays the assigned function of the [P0], [P1], [P2] and [P3] front panel keys. BATTERY CHARGING NOTE: Before detaching or attaching a battery pack, BE SURE to turn OFF the transceiver by rotating [VOL] fully counter clockwise, until it makes a "click" sound. Otherwise, a transceiver malfunction could occur. IMPORTANT: Battery charging caution Be sure the guide tabs on the battery pack are correctly aligned with the guide rails inside the charger. Tabs Guide rail DDCharging with the BC-160/BC-171 You can rapidly charge the Li-ion battery pack with the BC-160, or regularly charge the pack with the BC-171. Charging time for the BP-232WP BC-160: Approximately 3.5 hours BC-171: Approximately 11.5 hours Additionally needed item (purchase separately): •• A power adapter (may be supplied with the charger, depending on the charger version) or the DC power cable (OPC-515L). Power adapter Battery pack Transceiver + battery pack Turn OFF DDRapid charging with the BC-119N+AD-106 You can rapidly charge the Li-ion battery pack with the BC-119N. Charging time for the BP-232WP: Approximately 3.5 hours Additionally needed item (purchase separately): •• An AD-106 charger adapter •• A power adapter (may be supplied, depending on the charger version) or the DC power cable (OPC-515L/CP-23L) Transceiver + battery pack Power adapter Battery pack Turn OFF AD-106 charger adapter installed in the BC-119N. Optional OPC-515L* (for a 13.8 V power source) or CP-23L (for a 12 V cigarette lighter socket) can be used instead of the power adapter. * Polarity of the OPC-515L: White line: + Black line: _ CAUTION: DO NOT reverse the polarity when connecting the OPC-515L or OPC-656 to a power source. This will ruin the battery charger. DDAD-106 installation The AD-106 CHARGER ADAPTER must be installed into the BC-119N DESKTOP CHARGER or the BC-121N MULTI-CHARGER before charging the batteries. 1. Connect the BC-119N/BC-121N ribbon cables to the AD-106. 2. Install the AD-106 into the holder space of the BC119N/ BC-121N with the supplied screws. AD-106 Plugs LLThis illustration is for the BC-160. Optional OPC-515L (for a 13.8 V power source) or CP-23L (for a cigarette lighter socket) can be used instead of a power adapter. Sockets Screws supplied with the charger adapter LLThis illustration is for the BC-119N. DDRapid charging with the BC-121N+AD-106 You can rapidly and simultaneously charge up to 6 battery packs with the BC-121N. Charging time for the BP-232WP: Approximately 3.5 hours Additionally needed item (purchase separately): •• Six AD-106 charger adapters •• A BC-157S power adapter or the OPC-656 DC power cable Transceiver + battery pack Battery pack Turn OFF To an AC outlet AD-106 charger adapters installed in each slot. Power adapter OPC-656* DC power cable Connect to a 13.8 V, 7 A (minimum) power supply * Polarity of the OPC-656: Red line:+ Black line:_ DDCharging with the BC-197+AD-122 You can rapidly and simultaneously charge up to 6 battery packs with the BC-197. Charging time for the BP-232WP: Approximately 3.5 hours LLA power adapter may be supplied, depending on the charger version. LLFor details on the BC-197 multi-charger, see the instruction manual supplied with the charger. BASIC OPERATION DDTurning ON the transceiver NOTE: Before using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. See "BATTERY CHARGING" on this sheet. Rotate [VOL] to turn ON the transceiver. NOTE: •• If the transceiver is programmed for a start up password, enter the digit codes as directed by your dealer. •• The battery type must be selected, according to the attached battery type, when turning on the transceiver. LLAsk your dealer about entering the password or selecting the battery type. DDReceiving and Transmitting Receiving: 1. Select an operating channel. zzRotate [Rotary selector]. zzPush [CH Up] or [CH Down]. zzPush one of the direct channel select keys, [MR-CH 1] to [MR-CH 4]. 2. When receiving a call, rotate [VOL] to adjust the audio output level. Transmitting: CAUTION: DO NOT transmit without an antenna. It may damage the transceiver. 1. Wait until the channel is clear to avoid interference. 2. Hold down [PTT] to transmit. 3. Release [PTT] to receive. IMPORTANT: •• To maximize the readability of your signal, push [PTT], then pause briefly before you start speaking. •• Hold the microphone 5 to 10 cm from your mouth, then speak at your normal voice level. FREQUENCY RANGE AND OUTPUT POWER Model Version VHF Transceviers IC-F3260 series - USA-03 USA-04 USA-06 USA-23 USA-24 USA-26 EXP-07 EXP-27 UHF Transceivers AUS-01 IC-F4260 series AUS-21 EXP-04 EXP-05 EXP-06 EXP-24 EXP-25 EXP-26 DPM-25 Other Frequency Range 136-174 MHz 450-512 MHz 450-520 MHz 350-400 MHz 400-470 MHz Output Power 5 W 5 W •• Channel spacing: 6.25 kHz*1/12.5 kHz/20 kHz*2/25 kHz*3 *1 Only Digital mode *2 Only EUR and DPM versions *3 Except USA versions OPTIONS DDBATTERY PACKS •• BP-232WP LI-ION BATTERY PACK Voltage: 7.4 V Capacity: 2200 mAh (minimum) 2350 mAh (typical) Battery life: Approximately 12 hours When the power save function is ON, the GPS function is OFF, and the operating periods are calculated under the following conditions: TX:RX:standby = 5 : 5 : 90 •• BP-240/BP-261 BATTERY CASE Battery case for AAA (LR03) × 6 alkaline Battery case for AA (LR6) × 6 alkaline The BP-240 and BP-261 have IPX4 waterproof protection. When in use, the transceiver's waterproof rating meets IPX4. DDCHARGERS •• BC-119N DESKTOP CHARGER + AD-106 CHARGER ADAPTER + BC-145S POWER ADAPTER To rapid charge battery packs. A power adapter may be supplied, depending on the charger version. Charging time: Approximately 3.5 hours for the BP-232WP •• BC-121N MULTI CHARGER + AD-106 CHARGER ADAPTER (6 pieces) + BC-157S AC ADAPTER To simultaneously rapid charge up to 6 battery packs. A power adapter may be supplied, depending on the charger version. Charging time: Approximately 3.5 hours for the BP-232WP •• BC-160 DESKTOP CHARGER + BC-145S AC ADAPTER To rapid charge battery packs. A power adapter may be supplied, depending on the charger version. Charging time: Approximately 3.5 hours for the BP-232WP •• BC-171 DESKTOP CHARGER + BC-147S AC ADAPTER To regular charge battery packs. A power adapter may be supplied, depending on the charger version. Charging time: Approximately 11 hours for the BP-232WP •• BC-197 MULTI-CHARGER + AD-122 CHARGER ADAPTER (6 pieces) + BC-157S AC ADAPTER To simultaneously rapid charge up to 6 battery packs. A power adapter may be supplied, depending on the charger version. Charging time: Approximately 3.5 hours for the BP-232WP DDDC CABLES •• CP-23L CIGARETTE LIGHTER CABLES Used when charging battery packs using a 12 V cigarette lighter socket. For use with the BC-119N/BC-160/BC-171. •• OPC-515L/OPC-656 DC POWER CABLES Used when charging battery packs using a 13.8 V DC power source instead of the power adapter. OPC-515L: For the BC-119N/BC-160/BC-171 OPC-656: For the BC-121N/BC-197 DDBELT CLIPS •• MB-93 SWIVEL BELT CLIP •• MB-94R BELT CLIP Alligator-type belt clip. •• MB-96N/MB-96F LEATHER BELT HANGER DDANTENNAS •• FA-SC56VS/FA-SC57VS/FA-SC73US STUBBY ANTENNAS Shorter VHF or UHF antennas. FA-SC56VS: 150 ~ 162 MHz FA-SC57VS: 160 ~ 174 MHz FA-SC73US: 450 ~ 490 MHz •• FA-SC25V/FA-SC55V/FA-SC01U/FA-SC02U/FA-SC03U FA-SC25U/FA-SC57U/FA-SC72U FLEXIBLE ANTENNAS VHF or UHF antennas. FA-SC25V: 136 ~ 150 MHz FA-SC55V: 150 ~ 174 MHz FA-SC01U: 350 ~ 400 MHz FA-SC02U: 330 ~ 380 MHz FA-SC03U: 380 ~ 430 MHz FA-SC25U: 400 ~ 430 MHz FA-SC57U: 430 ~ 470 MHz FA-SC72U: 470 ~ 520 MHz •• FA-SC61VC/FA-SC61UC CUT ANTENNAS FA-SC61VC: 136 ~ 174 MHz FA-SC61UC: 380 ~ 520 MHz •• FA-SC62V/FA-SC63V HIGH GAIN ANTENNAS FA-SC62V: 150 ~ 160 MHz FA-SC63V: 155 ~ 165 MHz DDOTHERS •• AD-118 ACC ADAPTER Connects to an accessory which uses a HIROSE plug. See the instruction sheet of the AD-118 for details of the recommended accessories. CAUTION: The AD-118 is not waterproof. When it is connected, NEVER expose the adapter and the transceiver to rain, snow or any liquids. •• HM-184/HM-184H SPEAKER MICROPHONE Rugged type speaker microphones. The HM-184 and HM-184H meet IP67 requirements for dust-tight and waterproof protection. •• MB-130 VEHICLE CHARGER BRACKET Vehicle mounting bracket for the BC-160 battery charger •• VS-4MC PTT SWITCH CABLE + HS-94/HS-95/HS-97 HEADSET VS-4MC: Used to connect a headset to a transceiver. HS-94: Ear-hook type HS-95: Neck-arm type HS-97: Throat microphone LLThe VS-4MC meets IP54 requirements for dust-protection and splash resistance. Some options may not be available in some countries. Ask your dealer for details.