Icom IC-F5123D Instruction Manual - Page 12

Basic Operation

Get Icom IC-F5123D PDF manuals and user guides View all Icom IC-F5123D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

2 BASIC OPERATION ■ Turning ON the power q Push [ ] to turn ON the power. w If the transceiver is programmed for a start up password, input the digit codes as directed by your dealer. • The keys shown below can be used for password input: The transceiver detects numbers in the same block as identical. Therefore "01234" and "56789" are the same. KEY NUMBER 0 1 2 3 4 56789 e If the "PASSWORD" indication does not clear after inputting 6 digits, the input code number may be incorrect. Turn OFF the power and re-enter your password. ■ Channel selection There are several methods to select channels, and they may differ, depending on your system set up. NON-ZONE TYPE: To select the desired operating channel: • Push [CH Up] or [CH Down]. • Push one of [MR-CH 1] to [MR-CH 4]. ZONE TYPE: To select the desired operating channel: Push [Zone], then push [CH Up] or [CH Down]. AUTOMATIC SCAN TYPE: Channel setting is not necessary for this type. When turning ON the power, the transceiver automatically starts scanning. Scanning stops when a signal is detected. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
8
2
BASIC OPERATION
■
Turning ON the power
q
Push
[
]
to turn ON the power.
w
If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• The keys shown below can be used for password input:
The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
e
If the “PASSWORD” indication does not clear after input-
ting 6 digits, the input code number may be incorrect. Turn
OFF the power and re-enter your password.
■
Channel selection
There are several methods to select channels, and they may
differ, depending on your system set up.
NON-ZONE TYPE:
To select the desired operating channel:
• Push [CH Up] or [CH Down].
• Push one of [MR-CH 1] to [MR-CH 4].
ZONE TYPE:
To select the desired operating channel:
Push [Zone], then push [CH Up] or [CH Down].
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
ON the power, the transceiver automatically starts scanning.
Scanning stops when a signal is detected.
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6