Icom IC-F5123D Operating Guide - Page 18

3 IDAS OPERATION ■ Transmitting Position data When a GPS receiver is connected to the transceiver, the position (longitude and latitude) data can be automatically transmitted: • When the GPS request status message is received • After sending a voice message - Set the 'Send with Voice Call' item to 'Enable.' • After sending a status message - Set the 'Send with Status Call' item to 'Enable.' • After sending a message - Set the 'Send with SDM Call' item to 'Enable.' • After sending a Call Alert - Set the 'Send with Call Alert' item to 'Enable.' • After sending an Emergency call - Set the 'Send with Emergency' item to 'Enable.' Ask your dealer or system operator for connection details. ■ Transmitting Status messages A status message can be automatically transmitted. A status message is transmitted: • When the transceiver is turned ON or turned OFF - Set a status message to be transmitted in 'Power ON Status' or 'Power OFF Status' item, respectively. - Set the target station ID in 'Power Status ID.' • After sending a voice message - Set the 'Send with Voice Call' item to 'Enable.' - Set a status message to be transmitted in the 'Send Status Number' item. ■ Sounding a Horn The automatic honking function can be used when a horn is connected to the transceiver through the optional ACC cable OPC-1939 (D-Sub 15-pin) or OPC-2078 (D-Sub 25-pin). When a status message is received, the transceiver sounds the vehicle's horn for the specified time period to inform you that a status message has being received. This function is convenient when the operator is away from the transceiver. Ask your dealer or system operator, or refer to the IC-F5120D/ F6120D series service manual for connection and setting details. 15