Icom IC-F62D Accessories Guide - Page 3
Options
View all Icom IC-F62D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Options DDHM-222 speaker microphone Microphone [PTT] [Emer] Speaker Earphone jack Turn OFF the transceiver before attaching or detaching the microphone NOTE: ••NEVER immerse the connector in water. If the connector becomes wet, BE SURE to dry it before attaching to the transceiver. ••The microphone element is located at the top left of the speaker microphone, as shown in the illustration above. To maximize the readability of your transmitted audio, hold the microphone approximately 5 to 10 cm (2 to 4 inches) from your mouth, and then speak at your normal voice level. Belt clip You can connect an earphone (user supplied) to the earphone jack on the microphone. To attach: Attach the connector of the speaker microphone to the multi connector on the transceiver and tighten the screw. Turn OFF NOTE: KEEP the connector cover attached to the transceiver when the speaker microphone is not in use. Water will not get into the transceiver, even if the cover is not attached. However, the terminals (pins) will become rusty, or the transceiver will function abnormally if the connector becomes wet. Screw Coin CAUTION: Firmly attach to the multi connector, but do not overtighten. A loose connection will allow water intrusion into the connector. Over-tightening the connection can damage the transceiver. - 3 -