Icom IC-M25 Instruction Manual - Page 21
AquaQuake Water Draining function, Setting the Call channel
View all Icom IC-M25 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
BASIC OPERATION 4 AquaQuake Water Draining Setting the Call channel 1 function 2 You can recall the most often-used channel with a single operation, by setting the channel as the Call channel. 3 Water in the speaker grill may muffle the sound coming from the speaker. The AquaQuake Water Draining function The Call channel can be set in each channel group. 4 removes water from the speaker grill, by generating vibrating qqHold down [U/I/C] (CH/WX) for 1 second to change the 5 the speaker. channel group. Repeat to go to the desired group. 6 wwHold down [16/C] for 1 second to recall the current Call ➥ Hold down both [SCAN] and [Hi/Lo] for 1 second. channel in the selected group. 7 • A low vibration tone sounds for 10 seconds to drain water, regardless of the volume level setting. • T his function also stops when a key is pushed. • "CALL" and the Call channel number appear. eeHold down [16/C] again for 3 seconds (until a long beep 8 changes to 2 short beeps) to enter the Call channel 9 NOTE: This function does not activate when an external speaker microphone is connected. setting mode. • T he channel number starts blinking. 10 11 12 13 14 rrPush [Y] or [Z] to select the new Call channel. 15 16 ttPush [16/C] to set the displayed channel. • 2 short beeps sound. • T he channel number stops blinking. 13