Icom IP100H Precautions - Page 2

INITIALIZING IP1000C If you cannot access to the IP1000C setting screen, you can initialize (reset) the IP1000C by pushing [INIT] on the rear panel. • This initializing resets all settings to the factory defaults. • See the IP1000C instruction manual for initializing from the setting screen. 1 Disconnect all cables from the IP1000C, and then connect the AC adapter. • Verify that the [PWR] indicator lights green. 2 Push in and hold [INIT] with a pin on the rear panel until all indicators on the front panel light orange, and then release. [Operation] Rp‫ޙ‬ae໘naer෦l AC adapter Turn ON the power [LED indication] :Black out :Light :Blink Lights (Green) Push in and hold Use a pin Blinks ʢOrange/Greenʣ All LEDs lightʢOrangeʣ • When the initialization has been completed, [PWR] lights green. Release Blinks ʢGreenʣ Lights (Orange) Blinks (Orange) Lights (Green) ABOUT THE FIRMWARE UPDATE FUNCTION This function lights the [MSG] LED green to indicate that an IP1000C update is available. • To use the Firmware Update function, an internet connection, DNS and default gateway settings are necessary. See the IP1000C instruction manual for the setting details, or contact your Icom dealer or distributor for advice. NOTE: • NEVER turn OFF the power until the update has complet- ed. Otherwise, the IP1000C firmware may be damaged. • The firmware update cannot be performed during a conver- sation using the IP1000C. When [MSG] lights green When [MSG] lights green, a firmware update is available. Follow the procedures below to download and install the new firmware. Push in and hold [UPDATE] with a pin on the front panel until [MSG] blinks, and then release. • The IP1000C automatically starts the download and updates the firmware, and then reboots. [Operation] Front panel Push in and hold Use a pin [LED indication*] :Black out :Light :Blink Lights (Green) Blinks (Green) Release All LEDs light (Orange) After the rebooting, [PWR] lights green. *Indications other than [PWR] and [MSG] may differ, depending on the network environment (Except for when all LEDs light.) ABOUT THE AUTOMATIC FIRMWARE UPDATE FOR THE IP100H The IP100H has a function that checks for a firmware update while booting. If available, the IP100H automatically updates and then reboots when the update has completed. • The firmware may be updated and the IP100H reboots right after turning ON the power. • This "Automatic Firmware Update at Power ON" function can be set in Transceiver Settings > Transceiver Settings > Maintenance of the IP1000C setting screen. All stated specifications and design are subject to change without notice or obligation. Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the United Kingdom, Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries. All other products or brands are registered trademarks or trademarks of their respective holders. 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan A-7125W-1EX-q Printed in Japan © 2014-2017 Icom Inc.