Icom MXA-5000 Instruction Manual - Page 2

CONNECTIONS DATA PC DATA OUT OUT Bolting torque 0.22-0.25 N·m DATA IN Less than 2 mm Wire information AWG28 to AWG16 Stripped skin length 6-8 mm DO NOT use a solid conductor cable, otherwise the connected cable may be disconnected. Fuse replacement One fuse is installed in the supplied DC power cable. If a fuse blows or the receiver stops functioning, track down the source of the problem, if possible. Replace the damaged fuse with properly rated fuse. to antenna AIS receiver CAUTION: NEVER connect a 24 V DC power source directly. This will damage the receiver. Red 12 V battery VHF Marine transceiver This connection is not necessary if you have no VHF marine transceiver. Black PC DATA OUT DATA IN DATA OUT Navigation equipment Fuse rating: 0.5 A PC GPS receiver PC conncetion 15 69 D-sub 9 Pin Pin 2: Data Pin 5: Ground 1 13 14 25 Pin 3: Data D-sub 25 Pin Pin 7: Ground INSTALLATION q Attach the supplied angles to bottom side of the receiver, and tighten the two supplied screws (M3×6 mm) on each angle. Set screws Angle w M ount the receiver securely with the four supplied screws (M5×20 mm) to a flat surface which is more than 10 mm (13/32 inch) thick and can support more than 2 kg (4.4 lb). Self-tapping screw Spring washer Flat washer  SPECIFICATIONS D General • Frequency coverage : 161.975 MHz, 162.025 MHz • Type of emission : 16K0F1D (GMSK) • Antenna impedance : 50 W nominal • Operating temp. range : -20°C to +60°C; -4°F to +140°F • Power supply requirement : 12 V DC nominal (10.8 V to 15.6 V) (negative ground) • Current drain : 0.25 A • Dimensions (Projections not included) Without Angle : 132(W) × 34(H) × 155(D) mm 5 3⁄16(W) × 1 11⁄32(H) × 6 3⁄32(D) in Angle attached : 158(W) × 39(H) × 155(D) mm 6 7⁄32(W) × 1 17⁄32(H) × 6 3⁄32(D) in • Weight (Approx.) Without Angle : 400 g (14.1 oz) Angle attached : 460 g (16.2 oz) • DATA input interface : IEC61162-1: 2000 (4,800 bps) Sentence formatters : RMC, GGA, GNS, and GLL Input level : Less than 2 mA (When 2 V is applied) • DATA output interface : To navigation equipment : IEC61162-2 (38,400 bps) Sentence formatter : VDM Output level : 5 V, 40 mA max RS-422 ballanced type To PC : Baud rate 38,400 bps Sentence formatter : VDM Output level : ±5 V, ±35 mA typical RS-232C unballanced type D Receiver • Sensitivity : 0.35 µV (typical) • Adjacent channel selectivity : More than 70 dB • Spurious response : More than 70 dB • Intermodulation : More than 65 dB • Hum and noise : More than 40 dB • Conducted spurious emission : Less than -57 dBm All stated specifications are subject to change without notice or obligation. 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan A-6721H-1EX Printed in Japan © 2008 Icom Inc.