Image Fitness 8.0 Elliptical User Manual - Page 8

8. Identify the Left Handlebar (9) and the Left Handlebar 8 Leg (73), which are marked with stickers. Insert the Left Handlebar (9) into the Left Handlebar Leg (73). Make sure that the indicated tube on the Left Handlebar and the hexagonal holes in the Left Handlebar Leg are on the same side. Attach the Left Handlebar with two M8 x 42mm Button Bolts (50) and two M8 Nylon Locknuts (46). Do not tighten the Button Bolts yet. Attach the Right Handlebar (not shown) to the Right Handlebar Leg (not shown) in the same way. 9 50 73 Tube 46 Hexagonal Holes 9. Insert the Pivot Axle (38) into the Upright (2). Apply a generous amount of the included grease to the Pivot Axle. Identify the Left and Right Handlebars (9, 10), which are marked with stickers. Have another person hold the Left Handlebar near the left end of the Pivot Axle (38). Slide a Handlebar Spacer (25) onto the indicated tube on the Left Handlebar; make sure that the Handlebar Spacer is oriented as shown, with the smaller cutout on top. Then, slide the Left Handlebar onto the Pivot Axle. Assemble the Right Handlebar (10) in the same way. Tighten an M8 x 19mm Button Screw (22) with an M8 Large Washer (17) and a Small Wave Washer (90) into each end of the Pivot Axle (38). Make sure the Wave Washers are on the Pivot Axle. Orient the two Handlebar Caps (23) as shown, and press the small tabs on the Handlebar Caps into the two Handlebar Spacers (25). Gently separate the two Upright Covers (82). Hold the Upright Covers around the Upright (2), and firmly press the Upright Covers together. 9 82 9 Grease 17 90 22 Tube 23 Tab 38 25 2 10 23 22 90 17 25 82 10. Identify the Left Pedal (13), which has an "L" molded 10 into its bottom surface, and the Left Pedal Arm (14), which is marked with a sticker. Attach the Left Pedal (13) to the Left Pedal Arm (14) with two M8 x 46mm Button Screws (20) and two M8 Split Washers (74). Attach the Right Pedal (not shown) in the same way. 74 20 13 14 74 8