Image Fitness 8.25 Elliptical English Manual - Page 8

6. Apply a generous amount of grease to the axle on the left Upper Body Leg (6). Then, apply grease to a Large Wave Washer (20) and slide it onto the axle. Apply a generous amount of grease to the Left Crank Arm (42). Then, slide a Crank Arm Spacer (45) onto the Left Crank Arm. Make sure that the flat side of the Crank Arm Spacer is facing away from the Left Crank Arm. Slide the Left Pedal Arm (21) onto the left Upper Body Leg (6) and onto the Left Crank Arm (42). Repeat this step for the other side of the elliptical exerciser. 6 6 Grease 20 21 7. Attach the Left Pedal Arm (21) to the left Upper Body 7 Arm (6) with an M8 x 25mm Patch Screw (70), an M8 Washer (64), and a Pedal Leg Cover (23). Apply grease to a Large Wave Washer (20) and slide it onto the Left Crank Arm (42). Then, attach the Left Pedal Arm (21) to the Left Crank Arm with an M8 x 25mm Patch Screw (70) and an M8 Large Washer (81). 6 23 64 Repeat this step for the other side of the elliptical exerciser. 70 21 See step 3. Tighten the four M8 x 19mm Patch Screws (73). 8. The Console (10) requires four "AA" batteries (not included); alkaline batteries are recommended. IMPORTANT: If the ellipical exerciser has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become damaged. Remove the battery cover from the Console. Insert four batteries into the Console; make sure that the batteries are oriented as shown by the markings inside the battery compartment. Then, reattach the battery cover. 8 Battery Cover 10 Grease 42 45 73 Grease 70 81 20 42 8