Image Fitness Renew 631 English Manual - Page 9

3. The hydrotherapy spa operates on a 240 volt power source and must be wired directly to a 240 volt Ground Fault Circuit Interrupter (GFCI) installed in your home. This procedure must be performed by a qualified, licensed electrician. A wiring diagram is found on the inside of the electronics package for reference. Under no circumstances should the spa be wired by someone other than a qualified electrician. Before you have the spa wired, make sure it is in the desired position, and that it can be easily serviced, if needed. 4. After a qualified electrician has wired the spa to a 4 240 volt power source, refer to the inset drawing. Lift the filter cover (see assembly drawing 1) and insert the Filter (15), the Basket (4), and the Round Weir (3) into the filter housing. Remove the two warning decals (not shown) from the spa shell. Using a damp cloth, wipe the spa shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to easily service it. Once the spa is filled, it will have to be drained before it can be moved. See the inset drawing. Insert a garden hose or other clean water source into the filter housing. Fill the spa until the water level reaches the line directly below the decorative tile. Do not overfill the spa. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Replace the filter cover (see assembly drawing 1). Fill to Here Garden Hose 3 4 15 Filter Housing Filter Housing 5. Pull down one of the straps on the Spa Cover (11) and hold the Buckle (26) against one of the premium 5 cedar panels on the spa. (Note: To position the Buckle 11 correctly, have a second person hold the strap on the opposite side of the Spa Cover snug.) The Spa Cover must be snug. Do not place the Buckle over the grooves between the premium cedar panels. Refer to the inset drawing. Remove the latch from the Buckle (26). Attach the Buckle to the premium cedar panel with two #4 x 3/4" Screws (27). Attach the other three Buckles (26) to the premium cedar panels in the same way. Remove the Spa Cover (11) from the spa. Strap Latch 26 27 Strap 26 9