Image Fitness Renew 716 User Manual - Page 8
Assembly
View all Image Fitness Renew 716 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Assembly Before beginning assembly, carefully read the following information and instructions: • Place all parts in a cleared area and remove the packing materials from the spa shell. Do not dispose of the packing materials until assembly is completed and the spa is operating. • During assembly, make sure that all parts are oriented as shown in the drawings. • Read each assembly step before you begin. • Tighten all parts as you assemble them, unless instructed to do otherwise. ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included): • One phillips screwdriver A wire connector is provided on the electronics pack of the spa to connect a minimum No. 6 AWG (13.3 mm2) solid copper conductor between the spa and any metal equipment, electrical enclosure made of metal, metal water pipes, or conduit within five feet of the spa. 1. Before beginning assembly, make sure that you 1 have read and understand the information in the above and on the previous two pages. Remove the four #10 x 2" Sheet Metal Screws (46) that secure the indicated Access Panel (25) to the spa. Carefully remove the Access Panel and set it aside. Be careful not to damage the spa shell. 46 Spa Shell 25 46 2. Close the valve knob on the drain hose. Thread the cap onto the drain hose. Locate the two gate valves inside the access opening. Make sure that the gate valves are open and that the locking clips are snapped onto the stems of the gate valves, as shown in the inset drawing. Make sure that the four collars are tightened (there are two collars on the pump and two on the heater). Refer to step 1. Re-attach the Access Panel (25) to the spa. 2 Locking Clip 8 Gate Valve Collar Cap Valve Knob