InSinkErator Indulge Contemporary F-GN1100 Owners Manual - Page 3
Components In This Package, If Installing Only New Tank, If Installing Only New Faucet - sst fltr
View all InSinkErator Indulge Contemporary F-GN1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
COMPONENTS IN THIS PACKAGE F-HC3300 F-H3300 Brass Seat (HC3300, H3300) F-HC2200 F-HC2215 F-GN2200 F-GN2215 Rubber O-Ring Hex Nut F-HC1100 F-GN1100 Semi-circular Mounting Plate Plug (1) Hex Tool Y-Quick Connector Filter Head Filter Cartridge Snap-Connect Fitting (3 pieces) SST-FLTR 3/8" Tubes (2) Brass Nut/Ferrule/ Tube Insert 4 6" Filter Discharge Tube 3/4" Screws (4) If installing BOTH new faucet and new tank, skip to page 6. If installing only new faucet a T urn off water supply. Release Tab 1/4" blue 7/16" 5/16" white clear Release Ring R emove tubes from tank: At tank top, depress gray release tab into 1/4" 5/16" 7/16" quick-connect blue or clear white copper fitting securing blue or copper 1/4" tube and gently pull line out of fitting. Pull white 7/16" tube and clear 5/16" tube off fittings. Property Damage: Unplug tank before disconnecting tubing. R emove existing faucet and continue to page 6. If installing only new tank a TA ut rtnanokfftwopa,tedBreslpuurepespsTlyur.ebleease ring or gray release tab into quick-connect Make note of orientation of ferrule fitting securing blue or copper 1/4" tube and gently pull line off tank fitting. Pull white 7/16" tube and clear 5/16" tube off fittings. Blue Tube If not already equipped, the included snap-connect fitting must be installed. Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing. T o install snap-connect fitting, unscrew brass mounting nut and remove snap-connect fitting, brass ferrule and nut. b Check orientation of ferrule Blue Tube Blue Tube Property Damage: Do not over tighten brass nut. Blue Tube S lide brass nut and plastic ferrule onto the 1/4" blue or copper tube rInusnenBritnlbugleufreoTmourbtcheoepfpaeurcetut.be into snap- connect fitting and tighten brass nut with a wrench, 1 to 2 turns clockwise. Y ou may elect to use existing tank mounting bracket. S kip to Page 9, Steps 3-4 for complete installation instructions. 5